Emyplay EMB01-04R Wireless Fireworks Firing System Instruction Manual
- June 5, 2024
- Emyplay
Table of Contents
**Emyplay**
EMB01-04R Firing System
Instruction Manual
Thank you for purchasing this EMB01-04R Wireless Fireworks Firing System. Please read these instructions carefully for a thorough understanding of how the firing system operates.
CAUTIONS
- This product is only used for igniting fireworks. The user must use this product according to the local laws and regulations.
- Please keep the power off when you are connecting the fireworks.
- Please keep away from the fireworks when you are igniting them.
- It is low voltage alarm while the Power LED blinks, please replace the battery.
Product Feature
- 4 cue
- Remote controller FCC ID certified, Receiver module FCC & CE certified.
- Modes: Single Fire
- Frequency: OOK, 433MHz
- Transmitting Range:200 Meters.
- Supply Power: (1)Remote controller battery:12V23A battery; (2) Receiver battery: 9V Battery
- Could fire 3 pcs igniters in parallel or 6 pcs igniters in series.
- Temperature: -20 — 60
Item Included
| System | Remote controller | Receiver | Transmitting Rang |
|---|---|---|---|
| EMB01-04R | ETX200-4 | 4 pcs EMB01 | 200M |
Instructions
- Learn code of the remote controller: Turn the Function Switch off the receiver to “Single”, “Seq.0+” or “Seq.1+”. Keep pressing the Learn Button until the Status LED lights, press the button of the remote controller within 3 seconds, and the Status LED blinks.
- Turn the Group Switch to “G1”.
- The sequence number of the receiver is according to the learned number of the remote controller.
- Keep the power off, and connect the fireworks.
- Turn the Function Switch to “Test”. If the Test LED lights, the fireworks are connected well. Otherwise, it is not connected or it is bad.
- Turn the Function Switch to “Single”, “Seq.0+” or “Seq.1+”, keep away from the
fireworks, then press the button of the remote controller, the receiver will ignite the fireworks, and the Fire LED lights at the same time.
Mode
- Single Fire : Turn the Function Switch to “Single”, press the button of the remote controller which the receiver has learned the code, and the receiver will be fired.
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>