beko HSA32531N Chest Freezer Instruction Manual
- June 5, 2024
- Beko
Table of Contents
beko HSA32531N Chest Freezer
Packing Recycling
WARNING!
Do not allow children to play with the packing or with parts of it. There is
the risk of suffocation with parts of corrugated cardboard and with plastic
film. In order to get to you in good condition, the appliance was protected
with a suitable packing. All the materials of the packing are compatible with
the environment and recyclable. Please help us recycle the packing while
protecting the environment!
IMPORTANT!
Before putting the appliance in operation, read carefully and entirely these
instructions. They contain important information concerning the setting up,
use and maintenance of the apliance. The manufacturer is free of any
responsibility if the information in this document are not observed. Keep the
instructions in a safe place in order to reach them easily in case of need.
They can also be useful subsequently by another user.
ATTENTION!
This appliance must be used only for its intended purpose, (household use), in
suitable areas, far from rain, moisture or other weather conditions.
Transport instructions
The appliance must be transported, as much as possible, only in vertical
position. The packing must be in perfect condition during transport. If during
transport the appliance was put in horisontal position (only according to the
markings on the packing), it is advised that, before putting it into
operation, the appliance is left to rest for 4 hours in order to allow the
settling of the refrigerating circuit. The failure to to observe these
instructions can cause the breakdown of the motor compressor and the
cancellation of its warranty.
Warnings and general advice
- Do not plug in the appliance if you noticed a failure.
- The repairs must be done only by qualified personnel.
- In the following situations please unplug the appliance from the mains:
- when you defrost completely the appliance;
- when you clean the appliance.
To unplug the appliance, pull by the plug, not by the cable!
-
Ensure the minimum space between the appliance and the wall against which it is placed.
-
Do not climb on the appliance.
-
Do not allow the children to play or hide inside the appliance.
-
Never use electric appliances inside the freezer, for defrosting.
-
Do not use the appliance near heating appliances, cookers or other sources of heat and fire.
-
Do not leave the freezer door open more than it is necessary to put in or take out the food.
-
Do not leave the food in the appliance if it is not working.
-
Do not keep inside products containing flammable or explosive gases.
-
Do not keep inside fizzy drinks (juice, mineral water, champagne, etc.) in the freezer: the bottle can explode! Do not freeze drinks in plastic bottles.
-
Do not eat ice cubes or icecream immediately after having taken them out of the freezer because they may cause „freezer burns”.
-
Never touch cold metal parts or frozen food with wet hands because your hands can quickly freeze on the very cold surfaces.
-
For the protection of the appliance during warehousing and transport, it is provided with spacers between the door and the cabinet (in the front and rear side). These spacers will be removed before putting the appliance into operation.
-
Excess deposit of ice on the frame and the baskets should be removed regularly with the plastic scraper provided. Do not use any metal parts to remove the ice.
The presence of this ice build-up makes impossible to close the door correctly. -
If you do not use your appliance for a few days, it is not advisable to switch it off. If you do not use it for a longer period, please proceed as follows :
- unplug the appliance;
- empty the freezer;
- defrost it and clean it;
- leave the door open to avoid the formation of unpleasant smells.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
If your appliance has a lock, keep it locked and store the key in a safe place, out of the reach of children. If you are discarding an appliance with lock, make sure that, is made ineffective. This is very important so as to avoid children being trapped inside, which may cause their loss of life.
Setting up
This appliance was designed to operate at an ambient temperature between -150C
and + 430C. If the ambient temperature is above + 430C, inside the appliance
the temperature can increase. Set up the appliance far from any source of heat
and fire. Placing it in a warm room, the direct exposure to sunbeams or near a
heat source (heaters, cookers, ovens), will increase the energy consumption
and shorten the product life.
-
Please observe the following minimun distances:
-
100 cm from the cookers working with coal or oil;
-
150 cm from the electric and gas cookers.
-
Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2.
Assemble on the condenser (in the rear side) the supplied spacers. (Item 3 ).
-
Place the appliance in a perfectly even, dry and well-ventilated place. Assemble the supplied accessories.
Electric connection
Your appliance is intended to operate at a single-phase voltage of 220-240V/50
Hz. Before plugging in the appliance, please make sure that the parameters of
the mains in your house (voltage, currect type, frequency) comply to the
operation parameters of the appliance.
- The information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer.
- The electric installation must comply with the law requirements.
- The earthing of the appliance is compulsory. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions.
- The appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it.
- Do not use extension pieces or multiple adapters.
Switching off
The switching off must be possible by taking t he plug out of the socket or by
means of a m ains two-poles switch placed before the socket.
Operation
Before putting into operation, clean the inside of the appliance (see chapter „Cleaning”). A fter finishing this operation please plug i n the appliance, adjust the thermostat knob to an average position. The green and red LEDs in the signalling block must light. Leave the appliance work for about 2 hours without putting food inside it. The freezing of the fresh food is possible after min. 20 hours of operation.
Appliance description
- Door handle
- Door
- Tray
- Thermostat box
- Spacer for transport
Freezer operation
Temperature adjustment
The temperature of the freezer is adjusted by m eans of the knob assembled on
the thermostat (item. 4), position „MAX” being the lowest temperature. The
achieved temperatures can vary according to the conditions of use of the
appliance, such as: place of the appliance, ambient temperature, frequency of
door opening, extent of filling with food of the freezer. The position of the
thermostat knob will change according to these factors. Normally, for an
ambient temperature of approx. 320C, the thermostat will be adjusted on an
average position.
The signalling system is placed on the front side of the freezer (Item
5).
It includes:
- Thermostat adjustment knob – the inside temperature is adjusted.
- green LED – shows that the appliance is supplied with electric energy.
- red LED – damage – lights if the temperature in the freezer is too high. The LED will operate 15-45 minutes after the putting into operation of the freezer, then it must go off. If the LED goes on during the operation, this means that defects have occurred.
- LED Orange– fast freeze function activated
- by setting the knob to Superfreeze position the orange led goes on, showing that the appliance entered into the “fast freeze” mode. The exit of this mode is done automatically after 50 hours then the appliance runs in economic mode, and the orange led goes off. The three LEDs give information about the mode of operation of the freezer.
Advice for food conservation
The freezer is intended to keep the frozen f ood for a long time, as well as
to freeze fresh fo od. One of the main elements for a successful f ood
freezing is packing. The main conditions that the packing must fulfill are the
following: to be airtight, to be inert towards the packed food, to resist to
low temperatures, to be proof to liquids, grease, w ater vapours, smells, to
be able to be w ashed. These conditions are fulfilled by the following types
of packings: plastic or aluminium film, plastic and aliminium vessels, waxed
cardboard glasses or plastic glasses.
IMPORTANT!
- For freezing the fresh food please use the s upplied baskets of the appliance.
- Do not place into the freezer a too large quantity of food at a time. The quality of the food is best kept if they are deeply frozen as quickly as possible. This is why it is advisable not to exceed the freezing capacity of the appliance specified in the “Product Fiche”.
- The fresh food must not come into contact w ith the food already frozen.
- The fr ozen food you have bought can be placed i nto the freezer without having to adjust t he thermostat.
- If the f reezing date is not mentioned on the packing , please take into consideration a period of max. 3 months, as a general guide.
- The food, even partially defrosted, cannot be frozen again, it must be consumed immedi ately or cooked and then refrozen.
- The fizzy drinks will not be kept in the fr eezer.
- In case of a power failure, do not open the door of the appliance. The frozen food will not be affected if the failure lasts less than 36 hours.
Freezing with Superfrost
- Place the knob to super frost position. The Superfrost lamp comes on.
- Wait 24 hours.
- Place the fresh food in the freezer. In order to achieve fast freezing, food should be in contact with the interior walls when it is placed in the freezer.
- The Superfrost facility automatically switches the fast freezing procedure off after 50 hours.
Defrosting of the appliance
- We advise you to defrost the freezer at least twice a year or when the ice layer has an excessive thickness.
- The ice build-up is a normal phenomenon.
- The quantity and the rapidity of ice build-up depends on the ambient conditions and on the frequency of the door opening.
- We advise you to defrost the appliance when the quantity of frozen food is the least.
- Before defrosting, adjust the thermostat knob to a higher position so that the food stores more cold.
- Unplug the appliance.
- Take out the frozen food, wrap it in several sheets of paper and put them in refrigerator or a cool place. Take the separator panel and put it under the freezer in the direction of the dripping tube. Take out the obstructing plug. The water which results will be collected in the special tray (separator panel). After the melting of the ice and the run-off of the water please wipe with a cloth or with a sponge, then dry well. Put the obstruction plug back in its place.
(Item. 6)
For a fast thaw please leave the door open.
Inside cleaning
Before starting the cleaning, unplug the appliance from the mains.
- It is advisable to clean the appliance when you defrost it.
- Wash the inside with lukewarm water where you add some neutral detergent. Do not use soap, detergent, gasoline or acetone which can leave a strong odour.
- Wipe with a wet sponge and dry with a soft cloth.
During this operation, avoid the excess of water, in order to prevent its
entrance into the thermal insulation of the appliance, which would cause
unpleasant odours.
Do not forget to clean also the door gasket especially the bellow ribs, by
means of a clean cloth.
Outside cleaning
- Clean the outside of the freezer by means of a sponge soaked in soapy warm water, wipe with a soft cloth and dry.
- The cleaning of the outside part of the refrigerating circuit (motorcompressor, condenser, connection tubes) will be done with a soft brush or with the vacuum-cleaner. During this operation, please take care not to distort the tubes or detach the cables.
- Do not use scouring or abrasive materials !
- After having finished the cleaning, replace the accessories at their places and plug in the appliance.
Defects finding guide
The appliance does not work.
- There is a power failure.
- The plug of the supply cord is not inserted well into the socket.
- The fuse is blown.
- The thermostat is in „OFF” position.
The temperatures are not low enough(red LED on).
- The food prevents the door closing.
- The appliance was not placed correctly.
- The appliance is placed too close to a heat source.
- The thermostat knob is not in the correct position.
Excessive ice build-up
- The door was not closed properly.
- The following are not defects
- Possible noddings and cracks coming from the product: circulation of the refrigerant in the system.
Noises during operation
In order to keep the temperature at the value you have adjusted, the
compressor of the appliance starts periodically. The noises which can be heard
in such situation are normal. They are redced as soon as the appliance reaches
the operation temperature. The humming noise is made by the compressor. It can
become a little stronger when the compressor starts.The bubbling and gurgling
noises coming from the refrigerant circulating in the pipes of the appliance,
are normal operating noises.
Warning!
Never try to repair the appliance or its electric components. Any repair made
by an unauthorised person is dangerous for the user and can result in the
warranty cancellation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>