ShenZhen Shi Shan Qiu Trade E7 Wireless Stereo Headphone User Guide
- June 5, 2024
- Shen Zhen Shi Shan Qiu Trade
Table of Contents
E7 Wireless Stereo Headphone
USER GUIDE
Package Includes
- Wireless stereo headphone
- Charging cable
- 3.5mm audio cable
- Hard case
- User guide
Charging
Plug your headphones in to a power source using the included USB-B cable.
Rapidly flashing red when low battery Solid red when charging Solid red
light turn OFF when fully charged
Setup and Bluetooth Pairing
-
Turn on Bluetooth in your device settings.
Press the ON/OFF Button until the status light flashes blue and red. -
Select “Rockpapa E7” in the Devices list, then click Connect. Status light slowly flashing blue when Bluetooth paired.
Music and call control
| Press once to increase volume
Press and hold to skip forward
---|---
****| Press once to play, pause music
Press once to answer, end a phone call
Press and hold to reject a phone call
| Press once to decrease volume
Press and hold to skip back
| Press to power ON or OFF
Please read this manual carefully before use.
Safety warnings
** Do not place any naked flame sources, such as lighted candles Dispose of
batteries responsibly and be aware of the environmental effects of battery
disposal
Do not expose the batteries (batteries installed) to excessive heat, such as
fire or the like
Warning:** To prevent possible hearing damage, do not listen at high volume
levels for long periods. For your own safety, please be aware of your
surroundings when using these headphones. Not Suitable for Children
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. The device has been evaluated
to meet general RF exposure requirements.
Contact: Kelvin I[email protected] 90
Dayton Ave,
Passaic, NJ 07055, USrockpapa.com