Rowenta CF4132D0 Elite Multi Styler Hair Curler Instruction Manual
- June 5, 2024
- Rowenta
Table of Contents
Rowenta CF4132D0 Elite Multi Styler Hair Curler
OVERVIEW
Read the instructions carefully as well as the safety guidelines before use.
GENERAL DESCRIPTION
- Handle
- On/Off switch (1-0)
- “Power on” light
- Accessory locking – and unlocking – ring
- Swivel power lead
- Hair iron (16mm in diameter)
- Flat curling iron
- Extra large curling iron
- Massage hair brush
- Spiral hair brush
- Crimper/straightener crimping position plates 11b. Crimper/straightener straightening position plates
- 4 hairgrips
- Storage case
- 2 elite bobby pins
SAFETY
-
For your safety, this appliance complies with the applicable standards and regulations (Low Voltage Directive, Electromagnetic Compatibility, Environmental…).
The appliance’s accessories become very hot during use. Avoid contact with the skin. Make sure that the supply cord never comes into contact with the hot parts of the appliance. -
Check that the voltage of your electricity supply matches the voltage of your appliance. Any error when connecting the appliance can cause irreparable harm, not covered by the guarantee.
-
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask for installer for advice.
-
Burn hazard. Keep appliance out of reach from young children, particularly during use and cool down.
-
When the appliance is connected to the power supply, never leave it unattended.
-
Always place the appliance with the stand, if any, on a heat-resistant, stable #at surface.
-
The installation of the appliance and its use must however comply with the standards in force in your country.
-
WARNING : do not use this appliance near bathtubs, showers, basins or other vessels containing water.
-
When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched o!.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by Bchildren without supervision.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali$ed persons in order to avoid a hazard.
-
Stop using your appliance and contact an Authorised Service Centre if:
-
your appliance has fallen.
-
it does not work correctly.
-
The appliance must be unplugged:
-
before cleaning and maintenance procedures.
-
if it is not working correctly.
-
as soon as you have $nished using it.
-
if you leave the room, even momentarily.
-
Do not use if the cord is damaged.
-
Do not immerse or put under running water, even for cleaning purposes.
-
Do not hold with damp hands.
-
Do not hold the appliance by the casing, which is hot, but by the handle.
-
Do not unplug by pulling on the cord, rather pull out by the plug.
-
Do not use an electrical extension lead.
-
Do not clean with abrasive or corrosive products.
-
Do not use at temperatures below 0°C and above 35°C.
GUARANTEE
Your appliance is designed for use in the home only. It should not be used for professional purposes. The guarantee becomes null and void in the case of improper usage.
BEFORE FIRST USE
In order to avoid the risk of burns, attach the accessories to the appliance only when it is cool. Allow the accessories to cool down before storing them in the case. 3a / Placing and removing the irons:
- Place the irons on the handle
- Turn the screw ring located on the handle in order to lock the accessoryFollow the same procedure with all the irons. To remove, follow the inverse procedure. 3b / Placing and removing the brushes: Slide the brush on the curling iron while it is cool. . To remove the brushes, slide them in the opposite sense. 3c / Placing the crimper/straightener
- Place the crimper/straightener on the handle
- Turn the screw ring located on the handle in order to lock the accessory ) Keeping the crimper/straightener closed, set the accessory in the “crimp”position in order to use the crimping plates ($g.5a) or in the “straight” position ($g.5b) to use the straightening plates
PLUGGING IN YOUR HAIR STYLER
- When you have attached an accessory to the handle, place the appliance in a stable position on its rest, on a #at surface.
- Plug it in and set the On/O! switch to On (position 1). The ‘Power on’ light will come on and the accessory will begin to heat up
- Wait a few minutes to allow your hair styler to reach its working temperature (1-3 min. for the “iron” accessories; 6 min. for the crimping plates).
OPERATION
Use this product on clean, untangled, DRY hair (to avoid damaging your hair).
STYLING IRONS
- Gather a small section of hair (approx. 2 to 3 cm across).
- Press the lever to open the tong, then slip the tips of the hair between the roller and the tong.
- Release the lever to close the tong. Check that all the hair tips are correctly wound under the tong, in the direction of the curl.
- Hold the insulated plastic end with the other hand.
- Turn the styler to wind the section of hair around the accessory. Wind the hair, working towards the scalp. Take care not to burn yourself.
- Keep the iron in place for 10 to 15 seconds (longer for tight curls).
- Unwind the iron halfway, then open the tong and allow the section of hair to slide free.
- Repeat the procedure with di!erent sections of hair to form more curls.
PROFESSIONAL TIPS
- To create extra volume: divide your curls using your $ngers.
- To obtain really tight curls: wind small sections of hair at a time.
- For softer curls: wind on more hair.
- To prevent “yaway ends: check that the hair tips are trapped under the tong and lying in the direction of the curl.
- For a more natural, wavy look: lightly brush or comb your hair once the curls have cooled.
BRUSHES
- Take a strand of hair and roll it around the brush.
- Keep in place for 10 to 15 seconds, then unroll carefully.
- 2b Spiral brushes Fig 10 – Spiral curls (English style)
- Take a strand of hair and roll it around the brush.
- Keep in place for 10 to 15 seconds, then unroll carefully.
CRIMPER/STRAIGHTENER
- Gather a section of hair approximately 5 cm across, starting at the root of the hair.
- Press the lever to open the crimper attachment, and place the hair between the crimping plates.
- Close the crimping plates for around 10 seconds.
- Release the hair and start again just below the wave just formed.
PROFESSIONAL TIPS
- Always work from the roots towards the tips of the hair.
- To enhance the e#ect, you can apply styling mousse before crimping
- Your hair should be dry and tangle-free.
- Gather a section of hair approximately 5 cm across, starting at the root of the hair.
- Press the lever to open the straightening attachment, and place the hair between the straightening plates.
- Slide the appliance slowly down from the root to the tip of the hair.
CLEANING
- Unplug your styler and leave to cool on its stand.
- Clean accessories when fully cooled. To clean the handle, wipe with a soft, damp cloth.
- Never allow water or any other liquid to enter the handle.
ENVIRONMENT PROTECTION FIRST!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point. These instructions are also
available on our website www.rowenta.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>