NUHEARA NU318 IQbuds 2 MAX Personal Hearing Amplifier User Guide
- June 5, 2024
- NUHEARA
Table of Contents
NUHEARA NU318 IQbuds 2 MAX Personal Hearing Amplifier
IN THE BOX
CHARGING YOUR IQBUDS AND CASE
Your case carries and charges your IQbuds.
Your case provides you with the convenience of charging your IQbuds when you
are out and about.
You can charge your case via the USB cable connected to a USB power source
(Wall charger, computer, etc.)
The case has lights that indicate different states, please see below:
*
Please note that the lights will turn on when the case is opened or closed.
The lights will then turn off after a few seconds for battery efficiency.
- Your IQbuds will need to be in the case for the front lights to activate.
What Do These Lights Mean?
Battery Life
FITTING YOUR IQBUDS
INSERTING IQBUDS
Check the IQbuds for left and right markings to make sure you put the correct
bud in the correct ear.
Make sure the tip is at the bottom before inserting.
FIT LIKE AN EARPLUG
For high quality bass and noise reduction IQbuds need to form an airtight
seal.
Push the buds into your ears as you would an earplug.
EXPERIMENT WITH TIPS
Pick the largest size ear tip that fits in your ear comfortably and forms the
best seal.
The tips should pull off the IQbuds fairly easily, hold the silicone or foam
and pull to remove.
APP SETUP + PAIRING
TAP
TOUCH
These highlighted green surfaces are the tap sensors. You can control
different features with tap gestures.
PAIRING
To activate pairing mode, hold both tap sensors for about 5 seconds, Wait
until you hear “Pairing”.
This will allow your phone to discover your
IQbuds in bluetooth settings and in the app.
BLUETOOTH
iOS (Apple)
After the pairing screen you will be presented with different options based on
what software version your phone is running.
iPhones with iOS 13 and above will allow you to pair in the app. You will be
shown a pop up message asking you to pair, like this: Tap “Pair” and you will
be able to proceed through the app to complete the process.
If your iPhone is on a software version lower than iOS 13, you will be asked
to leave the app, go to bluetooth settings and connect to your IQbuds there,
see below: 
If
you are unsure of your phone software version, please go to:
Settings > General > About >
There will be an item called “Software Version” and the version number is
displayed next to it.
Android
After the pairing screen you will be presented with a pop up message asking
you to connect, like this: Tap “Connect” and you will be able to proceed
through the app to complete
the process.
If you have not activated pairing properly you may be taken back to the
pairing screen, in which case try the pairing action again and wait until you
hear “Pairing”. You will then be presented with the screen below: 
You
will be shown a connected screen and be able to proceed through the app.
TAP TOUCH CONTROLS
Please note the below are default settings. You can customize them in Tap
Touch in the app.
This allows you to pick and choose different functions to assign to different
tap gestures so you can personalize the way you control your IQbuds.
*Phone call functions cannot be changed 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>