seli MOD504 Module Camera Instruction Manual
- June 5, 2024
- seli
Table of Contents
seli MOD504 Module Camera
Introduction
This high-quality 12.3MP camera module adopts Sony’s IMX477R chip and requires a C or CS-mount lens to work. It is compatible with NVIDIA Jetson Nano series and Raspberry Pi CM3 compute module. The camera module offers higher resolution (12.3MP) and higher sensitivity (nearly 50% larger area per pixel for improved low-light performance) than IMX219 cameras, which can be used in industrial and consumer applications.
Features
- Sony IMX477R sensor with 12.3MP high resolution
- Larger area per pixel for improved low-light performance
- Back-illuminated sensor architecture for improved sensitivity
- Support for different C- and CS-mount lens
Specification
- Sensor Model: Sony IMX477R
- CMOS Diagonal Length: 7.9mm
- Resolution: 12.3 million pixels (4056×3040)
- Single Pixel Size: 1.5μm(H)×1.55μm(V)
- Output Format: RAW12/10/8, COMP8
- Back Focal Length: adjustable
- Lens Standard: C-mount/CS-mount (supporting C/CS connecting ring)
- l Infrared Filter: integrated
Settings for Jetson Nano Requirements
-
Hardware
-
Jetson Nano
-
Telephoto Lens x1 (or FIT0829)
-
12.3MP Camera Module x1
-
Wires
-
Step 1. Connect the camera, lens and Jetson Nano correctly, then power on the Jetson Nano module
-
Step 2. Download the Debian software pack of Jetson Nano and unzip to Jetson Nano.
-
Step 3. Input the following commands to install Debian
-
Step 4. Revise the file /boot/extlinux/extlinux.conf to make the changes take effect.
- For Jetson Nano developer kit version B01 and Jetson Nano 2GB developer kit, please replace the contenct in the file /boot/extlinux/extlinux.conf with the following:
- For Jetson Nano Developer Kit version A02, please replace it with the following:
-
Step 5. The module needs to be restarted for the changes to make effect.
Settings for Jetson Xavier NX
The way to set Jetson Xavier NX is basically the same as that of the Jetson Nano.
- Step 1. Connect the camera, lens and Jetson Xavier NX correctly, then power on the Jetson Nano module.
- Step 2. Download the Debian software pack of Jetson Xavier NX and unzip to Jetson Xavier NX.
- Step 3. Input the following commands to install Debian
- Step 4. Revise the file /boot/extlinux/extlinux.conf to make the changes take effect.
- Replace the contents of /boot/extlinux/extlinux.conf with the following
- Step 5. The module needs to be restarted for the changes to make effect.
Shooting Commands
- Real-time screen
- 1920×1080
- Press Ctrl+C to end.
- 4032×3040
- Press Ctrl+C to end.
- Record video in MP4
- 1920×1080
- Press Ctrl+C to end.
- 4032×3040
- Press Ctrl+C to end.
- Shoot in JPEG
- 1920×1080
- 4032×3040
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>