SUBMERSIBLE IP68 Waterproof Multi Color LED Lights Underwater Night Lamp User Manual
- June 5, 2024
- SUBMERSIBLE
Table of Contents
SUBMERSIBLE-IP68-Waterproof-Multi-Color-LED-Lights-Underwater-Night-Lamp-
product
General Description
It works well in both wet and dry place, such as swimming pool light, pound light, boat, foundation, aquarium fish tank, vase, flower pot,waterfall, bathtub, hot tub, and hallway, basement, garage, state, showcase,festival, holiday like Halloween, Christmas, wedding, birthday, event, party and other occasions as decor light, ambience light, ornight light indoor and outdoor decoration.
Feature
| Unit Dimension | Ø 85 * 30 mm |
|---|---|
| Increase | Magnets, Suction Cups |
| LED | 13 LED |
| Waterproof | Ip68 |
| Color | RGB (16 Colors ) |
| Color Changing | Yes |
| Dimmable | Yes |
| Control by | Radio Frequency |
| Dynamic Mode | Flash, Fade, Smooth |
| Timer | 2H, 4H, 6H |
| Light Battery | 3x AA (not included) |
| Remote Battery | 1 x Cr2025 Button Cell ( included ) |
| Light Battery Life | 35-50 Hours ( depends on the batteries and display mode |
| Remote Battery Life | 3-6 Month |
| Max Remote Range | 164FT/50M (in air), 16.4FT/5M (in water) |
| Power | 0.3-1.3w |
Tips for Timer Option
Button“2H“
( It means 2 hours on, and 22 hours off, circled by 24 hours ) Step: Press 2H
button→the light will keep on for 2 hours → it will turn off automatically(be
off 22 hour ) → light will turn on automatically again, and keep on 2 hours →
……le again in 24 hours (until the battery powers off )
Other timer options are same
- “4H”: 4 hours on, 20 hours off;
- ”6H”: 6 hours on, 18 hours off;
- “TIME OFF”Turn off timer, light will keep on until the battery powers off.
Check the left time of timer
keep the light on, press the button “ON”, how many times it flashes it
means how many hours it left.
Tips for Waterproof
- Please make sure the sealing ring is undamaged, and properly stay in the groove.
- Please twist up tightly, twist the light until the cap can not be twisted any further, to make it fully waterproof before putting it into water.( Very Important !!! please note and use it in the correct way)
- Please dry the lights first before replaceing batteries. Because the water outside lights may drop into lights and keep inside the battery case, it will damage the components, and defeat the lights.( Very Important!!!)
- It’s better not use in hot water, because the vapour may go into the light, it will damage the components and lead to stop working.
- Please keep the remote dry from water, because it’s not waterproof, water will make it stop working.
- It can not be used in beverage, and it is not intended for children under age of 6.
- Avoid directly looking at the bulb when activated.
Tips for Battery
- Please don’t use bad quality battery, it will influence thebrightness of the light and the service time, and it will harm for the light bulb too.
- For long time use, we recommend to use rechargeable battery like Ni-Mh battery to save batteries and money.
- We don’t suggest using carbon core battery, because it’s lightweight, and will make the light floating.
- If you don’t use for fllowing long time, please remove battries, it will help save battery energy and protect led bulb.
Tips for Remote Control
- Please remove the plastic insulating film on the bottom ofremote before using it, and keep the remote dry, because its not waterproof.
- Please long press the button “ON” on the remote forabout 2 second to activate all the lights. After turning on, no need to long press, the light will be very sensitive to react what you set.( very Important!!)
- Because our remote is radio frequency, so it may be disturbed by the signal nearby, please try to turn off other signal source nearby or keep closer to the lights.
- For underwater using, please keep the remote within 10FT/3M-16.4FT/5M, because water will largely absorb signal, and weaken the signal to the lights.
- In air, the remote range can reach 164FT/50M and more.
Tips for Suction Cups
- Can be used in both air and underwater on flat andsmooth surfaces.(not rough surface)
- Please clean the surface before attaching, make sure there is not any stuff between the surface and suction cup, especially remember to remove the lubricant like shower cream, moss etc. ( very Important!!)
- Please pull the suction cups vertically if you want to remove them, don’t pull it horizontally, it may pull out from the hole, there is the feature of design, it’s not suction cup problem. Please note and use it in correct way.
Tips for Magnetic
- It’s perfect for any iron place which can be attracted by magnet, especially rough vertical surface, but not for smooth vertical surface, please use suction cup instead.
- The magnet is strong, but it’s better to apply on pure iron surface, alloy may reduce the absorb effect.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>