Rxcap LTE Cellular Hub Instructions
- June 5, 2024
- Rxcap
Table of Contents
Rxcap LTE Cellular Hub
INSTRUCTIONS
The hub is operational only when connected to power source, please perform the following steps:
- Plug charger into wall outlet.
- Plug USB-C Cable into Charger.
- Plug USB-C Cable into Cellular Hub.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interierence received, including interference that may cause undesired operation.
CAUTION
- Changes or modifications not expressly approved by RxCap could void your authority to operate the equipment.
- This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Call us on
- 6178 809 361
Email us at
- contact@rxcap.com
- RxCap Inc.
- 14 Russet Ln.
- Lynnfield, MA, 01940
- +1 617 880 9361
declare under our sole responsibility that the product(s)
RxCap LTE HUB
complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device must be installed in a location where the antennas of the device will have a minimum distance of at least 20 cm from all persons. Using higher gain antennas and types of antennas not certified for use with this product is not allowed. The device shall not be co-located with another transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>