ROWENTA SO9065 Mini Excel ECO Energy Heater User Manual

ROWENTA SO9065 Mini Excel ECO Energy HeaterInstallntion

1. A. Control panel
2. B. Air intake grille
3. C. Removable, washable filter protecting the air inlet grille
4. D. Air outlet grille
5. E. Carry handle

It is essential that you read these instructions and observe the following recommendations

WARNINGS

• For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic Compatibility, Environmental Directives, etc.)
• The warranty will be invalid in the event of damage arising from incorrect use.
• Do not place your appliance immediately below a socket outlet.
• Do not operate your appliance in a dusty room or if there is a risk of fire.
• Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
• Never insert any objects inside the appliance (e.g.: needles)
• If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to avoid any danger.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and know-ledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Do not pull the power cord or the appliance, even to unplug it from the wall socket.
• Completely unwind the cord each time before use.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

VERY IMPORTANT

• WARNING : IN ORDER TO AVOID OVERHEATING DO NOT COVER THE HEATER
• Do not touch the appliance with wet hands.
• Do not use the appliance in damp places.
• Do not let water get into the appliance.
• Do not use this appliance near baths, showers, sinks or swimming pools.
• Do not use the appliance near inflammable objects and products (curtains, aerosols, solvents, etc.).
• Do not use the appliance when tilted or laid flat.
• In the event of prolonged absence: stop the appliance using button A1 and unplug.
• Never use the appliance without its filter.
• However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the safety standards in force in your country.

VOLTAGE

• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (double insulation

SAFETY

In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists or gets worse, a thermal fuse shuts the appliance down completely and it must then be taken to an approved service centre.

OPERATION

Before turning the unit on, make sure:

• it is positioned as described in these instructions,
• that it is placed on a flat and horizontal surface, and;
• that the air intake and outlet grilles are free of all obstacles.

When the appliance is connected to the mains electricity (plugged in), it is in “STANDBY” mode (Stop), and button A1 is lit; the electrical consumption of the appliance in standby is then less than 0.5W.
The appliance will emit a sound signal each time the control buttons are used .

1. Button A1 “STANDBY”: On / Standby
   This button enables you to activate the appliance or switch to standby.
   PLEASE NOTE: Whenever you switch it on, the appliance will function for about 1 minute (without adjusting) whatever the temperature in your room.
   A cooling cycle lasting for a few seconds is automatically activated before the appliance switches off; the button will flash during this cooling cycle.

2. Button A2 “SILENCE”: 1000W regulated “Silence” setting
   This setting enables you to automatically maintain the room temperature at the temperature you have selected using button A5 (in a normally insulated room whose volume corresponds to the power of this function).

3. Button A3 “MAX”: 1800W regulated setting
   This setting enables you to automatically maintain the room temperature at the temperature you have selected using button A5 (in a normally insulated room whose volume corresponds to the power of this function).

4. Button A4 “ECO ENERGY Function”: 1000W SILENCE automatically set at 21°C
   This setting enables you to automatically set the room temperature at 21°C on a half-power setting (1000W) in order to avoid excessive consumption.

5. Button A5: Thermostat (on SILENCE and MAX settings)

6. Temperature regulation: adjust the temperature to suit your chosen level of comfort.

7. Frost-free setting : this position enables you to automatically maintain the temperature above 0°C in a normally isolated area whose volume corresponds to the power of your appliance.

PLEASE NOTE: In order to control the temperature better, your appliance has a fan which will run for a few seconds every 5 minutes when the adjusting cycle has stopped.

CLEANING

• Your appliance must be unplugged before proceeding with any cleaning work.
• You can clean it with a slightly damp cloth.
• IMPORTANT: Never use abrasive products which might damage the appearance of your appliance.
• Your appliance is fitted whith a removable and washable dust filter (soap and warm water), which has to be cleaned regularly (Fig. 4a and 4b).
• Always ensure that the filter is thoroughly dry before replacing it.
• Never use the appliance without its filter.

STORAGE

• It is extremely important that the unit be allowed to cool down before it is put away.
• When you are not using your appliance, store it in a dry place.

IN THE EVENT OF PROBLEMS

• Never dismantle your appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Stop using your appliance and contact an Authorized Service Centre if :
  • your appliance has fallen
  • it does not work correctly
• Before contacting one of our Approved Service Centres, ensure that:
  • the appliance is set to normal operating mode;
  • the air inlet and outlet grilles are totally clear.

ENVIRONNEMENT PROTECTION FIRST!

Your appliance contains valuable materials which can be recovered or recycled. Leave it at a collection point.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>