Shenzhen Yuansu Chuangda Technology L13 Selfie Stick User Manual
- June 5, 2024
- Shenzhen Yuansu Chuangda Technology
Table of Contents
Shenzhen Yuansu Chuangda Technology L13 Selfie Stick
Overview
Compatible
How to use
-
Turn on: Slide the power key up to power on.
-
Bluetooth pairing: The indicator light flashes quickly for 4s to enter the pairing
state, the pairing status indicator flashes, use the mobile phone to search for “Selfie” to match, and the indicator light turns off after successful pairing. -
Taking pictures: When the remote control and the phone are connected, short press the camera button and the indicator light will flash.
-
No pairing: After power on, in the state of no pairing connection, it will automatically shut down if there is no operation for 5 mins.
-
Pairing: When the remote control is connected to the phone, it will enter the sleep state without any operation for 10mins, and it will automatically shut down after another 10 mins without any operation.
-
Turn off: In the power-on and hibernation state, slide the switch down to power off, and the indicator light flashes and then turns off.
Key Function
Use after taking out the Selfie and connecting the phone.
Take out the remote
Pull the rod out first, then slide it up to remove.
Clip phone
Use one end of the phone to push the clip upwards.
How to open a tripod
The bottom of the handle can be opened to open the tripod.
Adjust various angles
Adjust various angles to shoot.
Extendable
Extended and stable pole can be extended
Specification
- Main Material:Stainless steel+ABS
- Folded Length : 210mm
- Extended Length : 1130mm
- Product Reference : 210x55x35mm
- Product Weight : 200g
- Remote control battery : CR1632
( Batteries must not be exposed to sunlight, fire or similar excessive heat )
Remind
The selfie stick is compatible with Android 4. 4 and above & i OS 5. 0 and
above. ( Android device: I f y ou
change your volume key function on the camera, be sure to change it to the
default value. Or take a picture
and let the selfie stick to work normally)Thank you for your support.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>