NEBRA HNT Indoor Hotspot Miner ROCK Pi User Guide

June 5, 2024
NEBRA

NEBRA HNT Indoor Hotspot Miner ROCK Pi

SETUP GUIDE

  1. Download the Helium or Nebra app and create or restore a Helium wallet
  2. Screw the included antenna(s) into the connector(s) on the hotspot. If you are not sure which goes where, visit our detailed setup guides at nebra.io/hint
  3. If you are using a wired connection, plug an Ethernet cable in between a router and the Ethernet port on the hotspot
  4. Assemble the appropriate adapter for your country onto the universal power Supply, plug into mains power and insert povwer cable into the hotspot
  5. When the hotspot is powered up, the kower orange LED wil bo on t wil take up to 5 minutes to configure after the first boot
  6. When the device is ready the green LED will be visible. For devices with bhbetooth a slow fashing indicates the hotspot is ready for pairing. Pres and hokd the button for 10 seconds to activate pairing

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.

IC STATEMENT

This device complies with Industry Canada licence-exempt RSS standard(s) Operation is subject to the following two conditions:

  1. This device may not cause interference, and
  2. This device must accept any interference, including interference that may cause undesiredoperation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction withany other antenna or transmitter

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals