Shenzhen Haitao Sci Tech HT-503 4-in-1 LED Lamp Wireless Charger User Manual
- June 5, 2024
- Shenzhen Haitao Sci Tech
Table of Contents
15W Quick Charge
LED Lamp Wireless Charger
User Manual
Product Introduction
Thanks for purchasing our product quick charge LED lamp wireless charger. It adopts a high-end quick charge IC, with its luxury and compact design, it can be compatible with any mobile phone with QI standard. it can perfectly compatible with Sam sung, Apple fast charge wireless function, to save more time effectively and improve your charging experience.
Product Outline
Applicable Devices
- Devices with built-in quick charge/normal charge wireless receiver (Samsung Note 8, iPhone 8, etc)
- Devices with outer face wireless charging receiver (Samsung Galaxy S3, S4, S5, Note 3, Note 4, HUAWEI, LENOVO, XIAOMI, etc.)
- Devices with wireless charging receiver in their protective case iPhone 5/5s, iPhone 6, iPhone6p, etc.)
Note: All devices must be Qi standard.
Instructions
- Connect the wireless charger with the AC source by power adapter, the wireless charger turns on, and the indicator shows green color in 3 seconds and goes into the blue color in 15 seconds for standby mode.
- Put your phones onto the wireless charging area, and phones start to charge and the indicator shows flashing blue color, once phones are full charged , the blue indicator will keep lighting on.
- Light touch lamp switch, the lamp will light on, the lamp has 3 types of lighting mode, strong warm light, cold light, subdued light, then touch 1 more time to turn off.
Specifications
Input power : 30W(MAX)
Dimension: 120213250mm
Charging efficiency: 70%-80%
Output power: 15W/10W/7.5W/5W/3W
Input voltage: 5V3A 9V3A 12V2.5A
Standard Accessories
1 LED Lamp Wireless Charger
1 USB Cable
1* User Manual
Attention
- Please keep the charger away from water or other liquid.
- If you need to lean the charger, please make sure it is powered off.
- Using Environment temperature remains 1-45℃ degree.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm from the radiator of your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>