MOBASE ELECTRONICS MBECIBUS2109 Fob Key User Manual

: June 5, 2024
: MOBASE ELECTRONICS

Table of Contents

MOBASE ELECTRONICS MBECIBUS2109 Fob Key User Manual
MOBASE ELECTRONICS
- 2.1.2 Immobilizer & SSB(StartStopButton)
FCC warning statement:
15.105
15.21
FCC/ IC RF Radiation Exposure Statement:
IC warning statement:
Industry Canada ICES-003 Compliance Label:
- CAN ICES-3 Co-located
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MOBASE ELECTRONICS MBECIBUS2109 Fob Key User Manual

MOBASE ELECTRONICS

2. User Manual

2.1 Action Description

2.1.1 Fob Key

①lt has the function of manual START and input including the existing RKE function.

2.1.2 Immobilizer & SSB(StartStopButton)

FOB KEY has TP for ‘manual start through emergency authentication. C)It is a button to control engine start.
(1)To indicate the terminal status, two LEDs for the backlight and one light for the text are use C)It has a TP coil to take action in emergency situations.

FCC warning statement:

15.19 λ. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

15.105

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

15.21

Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or
End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure

FCC/ IC RF Radiation Exposure Statement:

This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 15cm between the radiator & your body.
This device complies with FCC/ ISED radiation exposure limits set forth for an uncontrolled environment.

IC warning statement:

RSS-Gen Issue 4 8.4

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.