godaddy PPST3 Poynt smart Terminal User Manual

PPST3 Poynt smart Terminal
User Manual

• SIM card needed fa Nub clot. whch requires a subscription plan. SIM cord not necessary for Wi-Fi

Sell Anything. Anywhere.
We have all the ways to help you sell more and grow your business.
For setup help. go to GoDaddy.com/smart-terminalihelp

Package Contents

• Device X 1
• Docking Station X 1
• USB-C Cable X 1
• Power Adapter X 1
• Plug Adapter Kit X 1
• Receipt Roll X 1
• Quick Start Guide X 1

5″ LCD
5″ Touch Panel| 480 x 800: RGB Multi-point. projected capacitive type, GG. Air bond
System Memory (RAM)| 2GB DDR3
Storage (Flash Memory)| 16GB
Communication
WLAN| 802.11 a/b/g/n/ac
WWAN| GSM (for EU). WCDMA, LTE/4G
WPAN| BT 4.2+HS compliant/ Dual Role
NFC| Supports major NFC/ contactless schemes.
IS014443 A&B. MiFare capable, ISO 18092 capable
Speaker| Mono with chambers, optimized for voice
Buzzer| 4.8KHz. 80dB @1C/cm
Sensors| 3-axis accelerometer. SAR sensor. Light sensor.
Printer| 2-inch Thermal Printer
Camera

Merchant-Facing Camera| 2MP
Barcode Scan Camera| 5MP
Payment Module – SoC| Maxim 32555
Power
Battery Pack| 5900mAh. 3.7V. 21.83Wh
Power Adapter| AC-DC, Input: 100-240VAC, Output: 5VDC. 3A
10 Port
SIM| Nano-SIM. Tray type
USB| USB-C
Card reader| Magnetic Strip. Chip
Button/Switch| Power/Sleep button Developer button (pinhole)
LED Indicator| System status – RGB LED. Merchant facing
Payment status – RGB LED, Customer facing
Housing| Plastic
Dimensions| Terminal: X-123mmY-273mm Z-99mm
Dock: X-122mm Y-84mm Z-32mm
Weight| Terminal: 0.9kg. Dock: 0.1kg
Dock| USB-A 2.0×2, RJ45 x1. RJ12 x1. USB-C x1 (power input only)

Review the Quick Start Guide before using the Poynt Smart Terminal. Visitsupport.poynt.com
Operating Environment
Voltage: AC input 100-240 VAC, 50/60 Hz; DC output 5VDC 3A
Temperature: 0° to 35°C
Long Term Storage Environment
Temperature: 5° to 30°C, relative humidity 20% to 75%
Warning: Read this guide for important safety and health information that applies to the Poynt device that you have purchased.
Failure to follow instructions and properly set up, use and care for this product can increase the risk of serious injury or death or damage to the device or devices.
Battery
This device contains a built-in lithium-ion battery. improper use of which may result in overheating. fire, and injury. The battery in this device is not user-replaceable and should only be replaced by an authorized service provider.
For optimal lithium-ion battery performance, follow the advised guidelines:

• Operating Environment Temperature.
• Storage Environment Temperature.
• Charge Poynt Smart Terminal with approved Docking Station or approved Power Adapter set to 100% full charge at least every 6 months.

CAUTION

• Risk of explosion if the battery is replaced by an incorrect type.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery. that can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
• A battery is subjected to the extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

Please note:

• Not following the above guidelines may result in the battery capacity draining quicker, increasing the duration to achieve a full charge, impeding the ability to achieve a full charge, and depleting the battery to zero capacity.
• Not following the above guidelines may result in the product not functioning, rendering it unusable or unrecoverable.

Disposal Information
Recycle and dispose of in accordance with local, state, and federal regulations. This device must be recycled or disposed of separately from household waste or recycling.
Regulatory Information
Regulatory information, certification, and compliance information can be found at poynt.com/legal. Check the A-labels from Settings Certifications.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ISED Compliance Statement
This device contains license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
SAR statement
This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is reported under this standard during product certification for use when properly worn on the body. The SAR test distance for the extremity is 0mm, and the SAR test distance for the body is 10mm.
California Proposition 65 Warning:
Warning: This product can expose you to DEHP, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
EU Compliance Statement
This product complies with the RED Directive 2014/53/EU,& RoHS 2011/65/EU.
Point of contact: Poynt, LLC,
Attn: Compliance, 2155 E GoDaddy Way, Tempe, AZ, 85284 USA
https://www.poynt.com/legal
Use Restriction: This device is restricted to indoor use when operating in the 5150 to 5350 MHz frequency range.
European Union- Disposal Information
This symbol on the product or its batteries or its packaging means that this product and any batteries it contains must not be disposed of with your household waste. Instead, it is your responsibility to hand this over to an applicable collection point for the recycling of batteries and electrical and electronic equipment.
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 0cm must be maintained between the user’s body and the handset, including the antenna. Hereby, Poynt, LLC declares that the radio equipment type PST3 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.poynt.com/legal.
This equipment complies with Directive 2014/53/EU radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the European Union market (France).
Certification Information:
SAR Limit:
Limbs: 4.0W/kg
Brain/Body: 2.0W/kg
SAR Value:
Limbs: 3.52W/kg
Brain/Body: 1.33W/kg
Maximum EIRP for EU

LIHUA

Client GoDaddy
Project 501514-01-GDD GDO-Poynt signup.| CS&R  10/19/2021
LCD Part Number 108416-02-GDD| |
Safety and Regulations
REV 06
PRINTS AS. Pantone Brack
Nomi 0.00 0.00 0.00 mm
Net Blank Size (if applicable) 617.05* 131.48 mm
80gsm Wood-free Paper Un-coated (0.09mm/3.7pt)
Corrugation/Grain (if applicable) horizontal
Print Instructions Offset 1C/Offset 1C
2285.9 mm| size 0 mm
Line Type Legend Construction (do not tool) Annotation (do not tool)
Cut
Crease
Reverse crease
PROPRIETARY and CONFIDENTIAL:
The information contained in this drawing is the sole property if Lihua Direct, LLC. Any reproduction in part, or as a whole with the written permission of Lihua Direct, LLC. is prohibited.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>