Unite Creation E80-A Wireless Lavalier Microphone User Manual

Unite Creation E80-A Wireless Lavalier Microphone

Introduction

Thanks for choosing our product. This product is a smart wireless microphone that provides professional-grade recording output, plug and play, no apprequired, multiples usages: it can be used in online live broadcast, video vlog shooting, program interview, recording, video teaching and other occasions. The wireless microphone consist of two parts, one is microphone transmitter the other one is receiver (See as below picture)

Overview

1. On/off Button: Power on: Short press the power button for 1 second, the green light flashes.
   Pairing: After the power-on is successful, plug the receiver into the mobile phone or other device, wait a moment.
   The connection will be successful in a few moments. At this time, the green light of the transmitter will be on and the red light of the receiver will be on.

Reverberation function: In the connected state, three-click the power button to turn on the reverberation, and the green light flashes. Three clicks to turn off the reverb, the green light is on.
Shut down: long press the power button for 3 seconds.
( Note: If the transmitter is not connected to the receiver within one minute, it will enter the shutdown state.)

2. Type-C Interface

3. Mode of Light

   • Power on: Green light flashes
   • Shut down: light off
   • Pairing: flashing green
   • Successful connection: the green light is on
   • Reverberation state: green light breathing flashing
   • Low battery status: 6 sec red light slow-flash till power empty
   • Charging: orange light
   • Charging completed: orange light off

4. Built-in microphone

5. Receiving terminal charging interface
   There is no battery in the receiving end, and there is no need to charge it during live broadcast. If live,when the battery of the mobile phone is low, you can directly use the power device to connect, the receiving interface charges the phone

6. Receiver (Lightning interface)

7. Receiver indicator

   • Pairing: red light flashes
   • Successful connection: the red light is on

How to use

1. Click the power button of the microphone, the indicator light will be green, it means the power on is successful.

Notice: When use this recording set, please plug in receiver to smartphone firstly and then turn on the transmitter microphone.

2. Insert the receiving end socket into the port of the mobile phone, the mobile phone displays a small icon to indicate connection succeeded.

3. The red light on the receiving end is always on, and the mobile phone opens the camera, live video and other APPs, you can use the microphone to pick up the sound.
   

Compatible

The wireless lavalier microphone is equipped with Type C and lightning connectors. It is compatible with iPhone/ iPad.

NOTICE: iPhone & iPad: If iPhone/iPad can not be matched. Please exit all open programs and restart the device.And it can not match iPhone 6 or older versions beacase the recording is done through then 3.5 audio port.

Professional designed for YouTube/Facebook live stream, TikTok, Creators, Vlogger, Blogger, Podcasters, interviewers.

Specification

• 2.46 private transmission protocol
• Low latency: 0.009s
• Frequency response: 20Hz-20KHz
• Sensitivity: -30db
• Signal to noise ratio: -65db
• Transmission distance: 20 meters
• Microphone pickup direction: 360-degree omnidirectional type
• Battery capacity: 75 mAh button battery
• Endurance: 6h

Contents

1. 2xMicrophone transmitter
2. 1xReceiver (Lightning interface)
3. 2xExtra foam Mic cover
4. 2xExtra rotating clip
5. 1x20W PD fast wall charger
6. 1xUser Manual
7. 2xUSB-C Charging cable (6 feet USB-C to C &1 feet USB to C)

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure statement.

The device can be used in portable exposure condition without restriction

• FCC ID: 2A6ZS-E80
• FCC ID: 2A6ZS-E80-A

Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>