Shenzhen Hengchuang Intelligent Electronic Technology HENCEKT Bone Bluetooth Headset User Manual
Table of Contents
Wireless Headset
User’s Manual
Product parameters
Product model: GD10
BT version:5.0
Connection distance: 10M
Waterproof grade: IPX 5
Battery capacity:120MA
Charging time:1.5H
Product weight:25G
Steps of pairing
- Long press the ON/OFFbutton for 3 seconds to start the headset and enter the pairing state(red and blue lights flash alternately, then off)
- Open the mobile phone Bluetooth to search for the GD10 Bluetooth device and click to connect. The blue lights are always on after pairing, and then off.
Charging
- Charge with the TYPE-Interface
- Charge with the on-board charger
- Charge with the charging plug Charge the product through a charger of 5V/1A or less.
Precautions
- If you don’t use headsets for the time being, please put them in the box to protect them from external damage and prevent them from being lost.
- Don’t put the product in a hot place.
- Don’t keep the product under the sun for a long time.
- If the product is not used for a long time, please fully charge it, and each charge will extend the battery life for a month.
- Please use a qualified 5V/1A charger to charge the product.
Packing list
- Headset
- User Manual
- TYPE-C Charging Cable
Warranty Card
Customer Name
Tel
customer address
Warranty reason:
Other information:
This product strictly implements the national three guarantee policy, we will give priority to the warranty users with complete information, so in order to restart the after-sales protection, please fill in this card. The final interpretation right of the product belongs to the company. Please keep the warranty card properly, we will use the warranty card as the warranty certificate.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>