homestore and more 066479 Rocks Waterfall Water Fountain Instruction Manual
- June 5, 2024
- homestore and more
Table of Contents
INSTRUCTION MANUAL
PLU: 066479 ROCKS WATERFALL WATER FOUNTAIN
Thank you for purchasing this fine decorative fountain. This product combines
our latest design with a creative theme and is carefully packaged, inspected,
and tested to ensure safe operation. The following instructions and safety
guidelines will enable you to use the product for trouble-free operation.
Please read the instructions and safety guidelines entirely before using the
product.
The product consists: (1) Fountain Top (2) Reservoir (3) Pump
Instructions for use:
- Remove the plastic bags from the packaging. Read this instruction sheet before proceeding.
- Place the base on a flat surface, and insert the reservoir onto the base.
- Read the pump user manual. Insert the water pump into the water tube.
- Insert the fountain top into the reservoir and put the pump into the water. The water should be higher than the pump.
- Make sure the water tube is properly connected with the pump and is not crimpled.
- The concave edge of the fountain top should adhere to the convex part of the reservoir. Be sure that the electric wire is passed through the wire opening.
- Connect the power cable to the outlet. If installed properly, water flow in the fountain will begin shortly.
- Please do not use the electrical plug-in in wet weather conditions.
- Please do not use it in adverse weather conditions. Please note: On first use, there may be air in the pump. It may take several minutes until all the air escapes.
Safety Guidelines:
- Read all instructions and safety guidelines thoroughly. Failure to follow guidelines and instructions could result in serious injury and/or property damage.
- Do not pump flammable liquids such as gasoline or fuel oil with the fountain pump.
- Make sure the water tube is properly connected with the pump and the upper layer, and the tube is not crimpled. This could cause a blockage, and water will not come out.
- During operation, the area around the pump will be covered with water. Take care when handling the pump; do not pull it out of the water (when running) by the power cord, and do not move the product while in operation.
- Unplug the pump from electric power before servicing, cleaning, or moving.
Cleaning and Maintenance:
- If, after time, the pump starts to lose power or stops working, you should check for the buildup of sediment or scale at the bottom of the pump housing, or in the reservoir.
- Remove the blockage or any dirt and scale which may have built up and close the case back up.
- Periodically change the water and keep the water clean. We recommend distilled water to prevent mineral build-up. This will improve the waterfall effect.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>