Godox MoveLink M2 Wireless Microphone Instructions
- June 5, 2024
- Godox
Table of Contents
Godox MoveLink M2 Wireless Microphone
WIRELESS MICROPHONE
- LOCAL RECORDING: ( Only Support TF Card)Pairing and connecting between phones on wireless mode. Hold the “REC” button until you hear a beep to start recording. Hold the “REC” button; the sound will pause one time during the recording to complete the recording. *Please note storage device like TF card needs to be inserted before startup. PLAY RECORDING: Press the “G/M” button to switch to MP3 play mode, then double click the “REC” button to replay the last recording. DELETE RECORDING: Hold the “REC” button to delete the current recording when playing recordings. ONE-KEY
- MUTE: Hold’ wireless music. button for one key mute function when playingWIRELESSWRECORDINGPower: Hold the “G/M” button to start the PARTY MIC. Connection wireless: enable the wireless of mobile phone, click to connect, successful connection if the prompt tone is produced.
Adjust voice
Adjust the volume of the MIC and the reverberation to a suitable level. RECORDING WITH MOBILE PHONEConnect the recording wire: insert the MICROplug of the recording wire into the MICRO interface and the 3.5mm interface into the earphone jack of the mobile phone. Using the PARTY MIC software on the phone select a recording app, select your favorite song, and proceed to record. Test and save the song using the provided instructions above. SELFIE FUNCTIONPress the “G/M” button to switch from wireless model to selfie mode; Enable wireless in the mobile phone, search “shutter”, click-connection; Open the photograph interface of the mobile phone, press the “M/V+” or “M4/V-” button to take photos. * Please note systems supported are 4.2.2 or higher version for Android, or higher version for IOS system.
FCC Statment
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: () this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interfèrence in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
timing the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>