Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke Amplifier User Manual

June 5, 2024
Martin Roland

Martin logo

Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke Amplifier

Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke
Amplifier

REMOTE CONTROL INSTRUCTION

Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke Amplifier fig
1

  1. POWER: Press it to turn on the unit, and press it again to turn it off.
  2. PLAY/PAUSE: Press to play, press again to pause.
  3. EQ: Sound field-effect button.
  4. MODE: Work mode select USB/SD/DVD/AUX.
  5. MUTE: Press it to mute down sound.
  6. !+./»I: Press »I to skip the next track. Press H<II to skip prev. track.
  7. VOL+/VOL-:Press it to adjust the volume level.
  8. REPEAT: Switch the repeat mode.
  9. SD/USB: Press it to turn the SD card and USB 10.0-9:Numeric buttons

SPECIFICATION

  • Output power (40) ……………………………………………………… 750W+750W
  • Output power (80) ……………………………………………………… SOOW+SOOW
  • Mic input sensitivity ……………………………………………………………… lOmV
  • External devices sensitivity …………………………………………………… 200mV
  • Signal/Noise ratio (with IHF A Filter) …………………………………….. 80dB
  • T.H.D (I KHz, 1 OW) ……………………………………………………………….. 0.1 %
  • Frequency band ……………………………………………………….. 25Hz – 20KHz
  • Mic tone adjustment: LOW …………………………………………. 80Hz ± 15dB
  • Mic tone adjustment: MID ……………………………………….. 3.5KHz ± 12dB
  • Mic tone adjustment: HI.. …………………………………………. 12KHz ± 15dB
  • Echo tone adjustment: LOW ………………………………………… 80Hz ± 15dB
  • Echo tone adjustment: HI.. ………………………………………… 12KHz ± 15dB
  • Music tone adjustment: LOW ……………………………………… lOOHz ± 15dB
  • Music tone adjustment: MID ……………………………………….. lKHz ± 12dB
  • Music tone adjustment: HI.. ………………………………………. 1 OKHz ± 15dB
  • Power source ………………………………………………….. AC 220V-240V 50Hz

INTRODUCTION

Thank you for purchasing the power amplifier, To take full advantage of the amplifier functions, and to enjoy long and trouble-free use, please read this user’s manual carefully.

IMPORTANT SAFETY INSTRUCTIONS

  1. Make sure that the line voltage in AC is 220-240V/50Hz If you are not sure, Kindly consult your appliance dealer or local power service company
  2. Please put the unit in a ventilated place. Do not operate in a sealed Box.
  3. Protect voltage line Avoid high pressure and stamp on, do not pull, or push excessively.
  4. Avoid any objects inserted into the unit. It may cause a short circuits and unit defect
  5. Avoid water, dust, and moisture. Do not put the Flower vase and another water container on the top of the unit.
  6.  Avoid cleaning with a volatile solution Do not spray insecticide. Do not clean with alcohol, painting, gasoline, etc.
  7. Avoid covering vents Block up the vents will make the temperature in the unit become higher and will damage the unit.
  8. Avoid opening the cover. Do not open, fix, or touch the inner parts, refer to qualified service personnel for help.

FEATURES

  1. Support Wireless Steaming/USE/SD
  2. 4 Microphone Input
  3. 32-bit digital key controller
  4. DSP effect digital processor
  5. Mp3 player compatible with lossless format songs play

FRONT PANEL INSTRUCTION

Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke Amplifier fig
2

  1. Mic 1 2 3 4 Jack

  2. Switch button for Mic. Feedback

  3. Mic -20dB Switch

  4. Mic Overload LED

  5. Mic 1 2 3 4 Volume Adjust

  6. Mic Balance Adjust

  7. Mic Echo Adjust

  8. Mic Low Tone Adjust

  9. Mic Middle Tone Adjust

  10. Mic High Tone Adjust

  11. Mono/stereo Switch

  12. Echo Volume Adjust

  13. Echo Low Tone Adjust

  14. Echo High Tone Adjust

  15. Echo Repeat Adjust

  16. Echo Delay Adjust

  17. SD Data Input Interface

  18. USB Data Inputlnterface

  19. MP3 Play/pause Switch

  20. MP3 Prev Switch

  21. MP3 Next Switch

  22. Mp3 Repeat Switch

  23. Instrumental without vocal or original sound

  24. MP3 Input Mode Switch

  25. Display Screen

  26. To transpose the key of the played music, rotate this control. The key can be changed in halftone steps in 5 steps; either higher or lower. To reset the key to the natural key, press this control. If over 5 seconds of silence occurs, the unit assumes the played song has finished and reset the key to natural.

  27.  Music Master Volume Adjust

  28. Music Volume Adjust

  29. Music Balance Adjust

  30. Music Low Tone Adjust

  31. Music Middle Tone Adjust

  32. Music High Tone Adjust

  33. DSP Effect Switch

  34. DSP X-bass Tone Adjust

  35. DSP Low Tone Adjust

  36. DSP Middle Tone Adjust

  37. DSP High Tone Adjust

  38. power Switch
    REAR PANEL INSTRUCTION Martin Roland MA-2500DSP 3-Way Mic Feedback
Karaoke Amplifier fig 3

  39. ACL 15V/230V Voltage Selector

  40. Ac 220-240V Power Source Input

  41. Right Channel Speaker Output

  42. Left Channel Speaker Output

  43. Fan Window

  44. Record Audio Output Jack

  45. Lien Audio Output Jack

  46. AUX Audio input jack

  47. DVD Audio input jack

DIAGRAM OF SYSTEM CONNECTION

Use the speaker of impedance 8 ohm, when use speaker terminal a or b

Martin Roland MA-2500DSP 3-Way Mic Feedback Karaoke Amplifier fig
4

Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Information to the user.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals