FAST LANE AD17271 Cyclone AX10 RC Car Instruction Manual
- June 5, 2024
- FAST LANE
Table of Contents
FAST LANE AD17271 Cyclone AX10 RC Car
PRECAUTIONS AND CARE
BATTERIES CAUTIONS
-
Non-rechargeable batteries are not to be recharged.
-
Rechargeable battens are only to be charged under audit supervision.
-
Different types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as Recommended are to be Use.
-
Battery chargers Used Win toy are to De regain examined tor damage to ne craping, enclosure and other parts. in the event of such damage, the toy must not be used with the charger until the damage has been repaired. battens are to be inserted with the comet plenty. Exhausted battens are to be removed iron the toy.
-
The supply terminals are not to be short-circuited. The toy must not be used with this charger unit the damage has been repaired.
-
Keep packaging and instruction manual because they contain important information. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Hues. these limits are designed to provide reasonable protection against harmful interference in a residential installation. this equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. It this equipment does cause nanmu interference to radio or television reception, which can De determined by turning the equipment off and On, the user is encourage to uy to correct the interference Dy one or more or the following means rues
-
Reorient or relocate there Vingantenna.
-
increase the Separation between the equipment and receiver.
-
connect the equipment an outlet on a circuit different from the radio which there reciever is connected
-
Consult the dealer or an experienced radio/TV technician for help.
CONTENT
-
Vehicle X 1
-
Iransmitter x
-
1 Rechargeable battery pack x 1
-
USB Charger
-
2 Hexagon nut
-
Hexagon nut sleeve x 1
-
Extra boay lip x4
-
instruction manual x 7
TRANSMITTER FUNCTIONS& BATTERY INSTALLATION
- Throttle trigger
- Steering wheel
- Power switch
- Power light
- Steering trim
- Throttle trim
- Low/High speed switch Remove the battery covers, place 4 x 1.5V AA batteries in the transmitter battery DOx, Following tne correct plenty. Alkaline battens recommended)
- Power switch
- Battery charging plug
- Battery Connector
- Chassis Connector
OPERATION
WARNING: This vehicle has 2 speed, Don’t put Low/High switch (7) to High speed on the controler before you can drive the vehicle skilled otherwise it is easy to crash on hard object to broke vehicle.
- Keep all the switches (5, 6, 7)0n the controller on tactory set.
- Put vehicle back on the ground, Switch transmitter power
- ON, the vehicle power (8) on, the LED ight
- on transmitter become Red and lashing, vehicle puts for 1-2 seconds, when it stop purrs and transmitter stop flashing and become red, they are paired automatically. 3. If no touch trigger of transmitter ( 1 ), the wheel spin automatically, adjust throttle trim (1 ) until it stop. 4. Put vehicle on the ground, pull the trigger of transmitter (1) slowly, if vehicle pulls to the left or right during forward driving, then adjust ST trim (3) untl it go straight.
- ready to run.
TIP 1: During the vehicle run in high speed, it is brake at first, not reverse
when you push throttle trigger
(1). TIP 2: Pull the throttle trigger (1 ) slowly for controlled acceleration.
Turning steering wheel (2) slowly for different turning angle.
- To open body by pulling out 4 body clips ( 11 ) from the body,
- Make sure the vehicle power switch ON/OFF (8) is on the OFF position.
- Disconnect battery connector (10) with chassis connector (12)
- Connect battery charging white plug (9) with USB charger tightly as shown as side.
- Red LED light on charger turn on, allow battery to charge 2-3 hours, when it turns off, it indicate battery is full.
- Running time approx. 10-15 minutes depending on terrain and driving style.
TROUBLESHOOTING
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>