GOODLIFE Dog Silencer MAX Ultrasonic Anti-Bark Control System Instruction Manual
- June 5, 2024
- GOODLIFE
Table of Contents
GOODLIFE Dog Silencer MAX Ultrasonic Anti-Bark Control System
Included In Your Package
Sold Separately
Before We Get Started
WHAT IS ULTRASONIC SOUND?
Ultrasonic sounds are frequencies that are higher than the range of human
hearing. However, they can be very irritating to dogs. Ultrasonic sound has
been used for over a century to successfully train dogs.
HOW LONG WILL TRAINING TAKE?
Some dogs take longer to train than others and bad habits are sometimes hard
to break. Allow 2-3 weeks to see results.
WHERE CAN I USE IT?
You can stop barking from anywhere that you have a clear line of sight. Hang
your Dog Silencer MAX on a tree, mount it on a fence…the list goes on. For
perfect placement every time, use the optional Wall Mount with pan and tilt
(sold separately).
It’s Time to Stop Barking. Ready?
- Plug it in or Use Batteries
I WANT TO PLUG IT IN ( OPTIONAL EXTENSION )
Use the AC adapter when close enough to a power source. You can also use the
optional extension (sold separately) for longer distances. Ideal for indoors,
smaller yards, and close to your home. DC 9V
Important! When using AC power make sure to remove batteries.
I WANT TO USE BATTERIES
Use battery power when using the Dog Silencer MAX in large yards or with dogs that are far away from an AC outlet. Simply insert 6 AA batteries into the battery compartment located in the back of the unit. Typical battery life is 4-5 weeks.
- How Far Away is the Dog?
- Lift the rubber protective cover on the side of the Dog Silencer and slide the Power Switch to ‘Ultra’.
- Place the Dog Silencer MAX in a location where it has a clear line of sight to the dog. From there, adjust the Bark Sensitivity Dial as shown below:
Slide the Power Switch to ‘Audio’ while configuring the Bark Sensitivity Dial. This way, you can hear when the Dog Silencer MAX activates and adjust the sensitivity accordingly. Audio also works great for dogs with some hearing loss. IMPORTANT: The Bark Sensitivity Dial is not a volume dial. The volume on the Dog Silencer is always set to the maximum and is not adjustable- Installing Your Dog Silencer Max
WHERE DOES IT GO?
You have several options. Set the Dog Silencer MAX on a flat surface, or for
extra stability, pull out the sliding mounts on the bottom and fasten it down.
You can also hang the Dog Silencer MAX using a screw or nail and the mounting
holes on the back of the device. For maximum flexibility, try the optional
Wall Mount with pan and tilt (sold separately).
DO I NEED A CLEAR LINE OF SIGHT?
Yes, ensure that you have a clear line of sight between the Dog Silencer and
the dog you are trying to train. Ultrasonic sound will not travel through
solid objects like walls and fences nor through thick foliage or hedges.
WHEN DO I USE THE REMOTE?
Use the remote to trigger the Dog Silencer MAX manually when the dog is
outside the 75 ft. automatic bark detection range. While the remote will
activate the unit from up to 75 feet away, the Dog Silencer MAX must be turned
on (set to either ‘Audio’ or ‘Ultra’) in order for the remote to work.
Did you know you can use the remote to train other unwanted behaviors as
well? Simply turn the Bark Sensitivity Dial all the way down so that the Dog
Silencer MAX won’t be triggered by barking. Instead the unit will only
activate when you press the remote. This is perfect for targeting other
unwanted behaviors such as jumping on furniture, begging, etc. NOTE: The
remote uses a CR2025 3V battery which can be replaced by unfastening the 4
screws on the back of the unit to open the body of the remote.
- Success
Congratulations! You’re all set. In the unlikely event you run into any issues, please see the “Troubleshooting” section on the next page or contact us using the information under “We’re Here to Help”. For more tips on how to train your dog with the Dog Silencer MAX, visit our blog: goodlife.click/dog- silencer-tips or contact us using the information in the “We’re Here to Help section” on the next page.
Troubleshooting
THE DOG IS BARKING THE SAME OR MORE THAN BEFORE!
No problem. Dogs may bark a little more at the start of the training process.
This is only temporary while the dog is being deterred by the ultrasonic sound
and is trying to resist training.
IS THIS DEVICE LEGAL TO USE ON A NEIGHBOR’S DOG?
Because the Dog Silencer relies on ultrasonic sound as a training method, it
is outside the human hearing range and is not typically covered under noise
ordinances. Additionally, due to the way noise is measured (A-weighting), the
Dog Silencer can normally be used in environments where OSHA regulates
ultrasonic sound levels. That said, we don’t recommend using the Audio setting
for neighbor’s dogs.
THE DEVICE ACTIVATES EVEN WHEN THE DOG DOESN’T BARK!
You might have the bark sensor set too high, which means it may be activating
to noises unrelated to barking. Try turning the bark sensor down slightly so
that noise or loud sounds do not trigger it.
ARE THERE ANY DOGS THIS WON’T WORK ON?
We don’t recommend the Dog Silencer for dogs younger than 1 year as their ears
are still developing and may be very sensitive. Older dogs may have high-
frequency hearing loss that could prevent the ultrasonic sound from being
effective. Check with your veterinarian if you have a puppy or suspect that
your dog has hearing loss.
SHOULD I USE THE ‘AUDIO’ SETTING?
You have two options – the ‘Ultra’ setting emits ultrasonic sound while
‘Audio’ emits both ultrasonic and audible sounds at the same time. We’ve found
customers have the most success using the ‘Ultra’ setting, but if you have an
especially stubborn dog, try ‘Audio’.
INSTINCTUAL VS. HABITUAL BARKING
Heads up! Instinctual, territorial and protective barking may be more
difficult to train than barking out of boredom or habit.
Returns & Exchanges
Don’t worry, we’ve got you covered! Your Dog Silencer is backed by our 60-Day Money-Back Guarantee and 1-Year Protection Plan. In the unlikely event you need to use either of these, just contact us and we’ll make it right. If you bought your Dog Silencer from a retail location, please contact the store directly for return details. If instead your purchase was made through Good Life, please visit ultimatebarkcontrol.com/pages/ returns-exchanges or contact us using the information below for full details. Need more? You can extend the Protection Plan on your Dog Silencer to 2 or 3 years, or even add accidental coverage by purchasing one of our easy Protection Plans. Visit us at ultimatebarkcontrol.com/pages/protection- plans or contact us using the information below.
We’re Here to Help
- Toll-Free: 1-800-657-8214
- Outside the US: 1-541-245-4488
- Website: ultimatebarkcontrol.com
- Email: customerservice@goodlifeinc.com
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Caution
Changes or Modifications not expressly approved by the party responsible could
void the user’s authority to operate this device.
Warning
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions. This product needs power supplied by
an adapter that can meet LPS. The maximum operating temperature is 45°C.
References
- No-shock dog barking collars and devices for your dog or the neighbors – Ultimate Bark Control
- Protection Plans – Ultimate Bark Control
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>