PARAMITA Amita P5 ENC Wireless Earphone Instruction Manual

PARAMITA Amita P5 ENC Wireless Earphone

Precautions

Thank you for purchasing the Environmental Noise Cancelling True Wireless Bluetooth Headphones produced by our company. For listening experience, please wear and use the headset correctly, and do not disassemble the hardware by yourself. Please read this manual carefully before use, thank you again for your support and love.

Specification

il t i r c u o c n t e io e n a m rb a u n d u s a , **l**

Schematic Diagram

1. Touch sensing area
2. Charging interface
3. Charging case indicator

Function Overview

Steps:

1. Power on: Open the charging case, take out the earbuds, and turn it on.
2. Bluetooth Pairing: Turn on the “Bluetooth” of the device and take out the earbuds from the charging case, search for “ Amita P5 ” and click “connect”. When using the headset again, open the charging case, take out the earbuds, and the earbuds will automatically connect to the device.

Warm tips:
If the pairing fails, put the earbuds into the charging case, and then try the steps above again, the earbuds will automatically shut down when there is no devices to connect in 5 minutes.

Charging Operation

1. Charging Case Charging:
   Connect the charging cable to the charging port on the charging case.

2. Earbuds Charging:
   Put the earbuds into the charging case, the earbuds will automatically shut down and charge

Function Definition

Charging And Indicator Light Display

SAFETY MATTERS

1. Do not throw the product into the fire to avoid an explosion.
2. The product should avoid rain, dampness, or other liquids.
3. While using the product for the first time, fully charges before using it.
4. Using the earbuds for the first time, please adjust the volume to reasonably, then gently switch to the appropriate volume, if the volume is too high, might cause tinnitus or damage to the ear and the product itself.
5. Please use the original battery and original charger.

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>