Vinten 3490-3 Heavy-Duty Quickfix Adaptor Instruction Manual
- June 5, 2024
- Vinten
Table of Contents
Vinten 3490-3 Heavy-Duty Quickfix Adaptor
Introduction
The heavy duty Quickfix adaptor allows a pan and tilt head with a ‘Quickfix’ base to be installed on a standard Vinten four-hole mounting.
WARNING! Maximum payload capacity 100kg (220 lb). Do not use inverted unless a secondary anchor (such as a chain) is in use to secure the head.
Installation
Install the adaptor on the four-hole mounting using the screws provided
WARNING! Ensure that the screws engage sufficiently for safety, but do not protrude above the adaptor mounting face.
To fit a head
NOTE: If the head does not have a ‘Quickfix’ base, a ‘Quickfix’ ring (Part No: 3101-3) is available from your Vinten supplier.
- Push up the red safety latch and unlock the adaptor by pulling the lever fully outwards and to the left.
- Position the head in the adaptor, ensuring that it seats correctly in the recess and the safety button is depressed.
- Lock the head in the adaptor by pushing the lever fully inwards to the right until the red safety latch operates.
To remove a head
Push up the red safety latch and unlock the adaptor by pulling the lever fully
outwards and to the left.
WARNING! This unit contains a spring under tension. Removal of the backplate may cause personal injury.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>