ROAMAN RMS8101 IPX7 Electric Razor Shaver User Manual

June 5, 2024
ROAMAN

ROAMAN RMS8101 IPX7 Electric Razor Shaver

General Information

Introduction

Thank you for your purchase. Please read this user manual as it contains information about the wonderful features of this shaver as well as some tips to make your shaving easier and more enjoyable.

Attention

  • Please read the user manual carefully before using this product, and keep for future reference.
  • Close supervision is necessary when this shaver is used in the presence of children. Please note that this shaver is not for children to play.
  • To avoid injury, never use the shaver if there is any damage.
  • The temperature range to operate, store and charge this product is 0 C – 40 C.
  • The shaver is designed to be IPX7 waterproof and can be washed directly under the water. It’s not suggested to immerse the shaver under water for a long time, which will reduce the lifetime of the shaver. Please carefully check the water temperature to prevent hands from being burned.
  • When you are on a trip, make sure the protective cover is on to protect the shaver heads. If there is a significant change in temperature, pressure, or humidity, please allow the shaver 30 minutes adaptation to new conditions before use. If the electric shaver will be in lock mode, press the button for 3 seconds to unlock.
  • Use the USB charging cable in the package. Please the shaver to an AC outlet with 5V output or less.

Charging Instruction

Charging
When the shaver is charging, the LED displays will initially light on one by one then turn off gradually. The remaining battery power status will be displayed by a percentage indicator. When battery power is less than 10%, the battery percentage indicating light will turn a flashing red. When it reaches over 10% capacity, the light will turn white and flash. When the shaver is fully charged, the light will stop flashing and remain steady.

Full Charge
Fully charging the shaver requires 1 hour. This will give approximately 120 minutes shaving time. When fully charged, the battery percentage indicating light will be always on.

Low Battery
When the first indicating light turns a flashing red, the shaver requires recharging.

Charging operation procedure

  • A: Connect the Micro USB port to the shaver charging port.
  • B: Insert the USB plug into the USB charger.
  • C: After the battery is fully charged, unplug the charger from socket and then unplug the USB cable from the shaver.

Cleaning Tips
The cleaning indicator light will flash for 30 seconds if operational for over 2 minutes, and it means cleaning is required.

Traveling lock
Press the on/off button for 3 seconds. Lock mode is engaged when indicator lights flash. Please lock the shaver before carrying it on a trip to prevent the shaver turning on unexpectedly.

Usage

Use the USB charging cable in the package. Please connect the shaver to an AC outlet with 5V output or less.

  • A. Press the on/off button to turn on the shaver.
  • B. The shaving heads flex to the contours of your skin. Your skin may need 2-3 weeks to adapt to the shaving system.
  • C. Trimming sideburns: push the slider under the sideburn trimmer down to make the sideburn trimmer pop out.
  • D. After shaving, press the on/off button to turn off the shaver; then put on a protective cover to prevent damage.
    Note: Please make sure the charger output voltages5V.

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions are required to always be followed including the following.
Read all instructions before using(this appliance).

  1. The appliance is intended for household use only.
  2. Plug charger directly into the receptacle, do not use an extension cord.
  3. Unplug the charger before plugging or unplugging the appliance.

DANGER-TO reduce the risk of electric shock:

  1. Except when charging, always unplug this appliance from the electrical outlet immediately after use.
  2. Unplug this appliance before cleaning.

WARNING-TO reduce the risk of burns, fire, electric shock, or injury to persons

  1. This appliance is not intended for use by persons (including children)with reduced physical sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
    Children should be supervised to ensure that they do not play with the appliance.

  2. Use this appliance only for its intended use as described in this manual.
    Do not use attachments not specified by the manufacturer.

  3. Never operate this appliance when it has a damaged cord or plug when it is not working properly after it has been dropped or damaged, or after it has been dropped into water Return the appliance to a service center for examination and repair.

  4. Keep the cord away from heated surfaces.

  5.  Keep the air openings free of lint, hair, and similar objects.

  6. Never drop or insert any object into any opening.

  7. Do not use outdoors or operate while aerosol (spray) products are being used.

  8. Do not use this appliance with a damaged or broken comb, as it has the potential to result in facial injury.

  9. Always attach plug to appliance first, then to outlet. To disconnect turn all controls to off position e.g (“o”) then remove plug from outlet.

  10. USE ADAPTOR GQ06-050100-ZU ONLY.

Cleaning & Maintenance

Important: Do not use compressed air, scouring pads, abrasive cleaning agents, petrol, acetone and other corrosive liquid to clean the shaver.

  • You can rinse the shaver under the tap or clean it with a brush which is included in the package.

  • Be careful when using hot water. Always check the water temperature to make sure it is not too high to prevent scalding.

  • Clean it each time after shaving to obtain the best shaving pertormance.

  • A damp cloth may be used to clean the outside of the shaver, but do not wipe the shaver blade parts with a towel or tissue, as this may damage the shaver blades as well as risk personal injury.

  • Switch off the shaver.

  • Press the release button, and open the shaving units.

  • Tum the locking device (A) by counterclockwise rotation, taking Out the fixing rack (B).

  • Gently take out and clean the shaving heads one by one, being careful not to touch the blades. Each shaving head contains one shaver head blade
    and one guard.

  • Pull out the shaver blades from the shaver.
    Note: Do not clean more than one blade and housing unit at one time as they are matched with each other. If accidentally mixed up, it may take several weeks to recover the best shaving performance.

  • Remove the blade from the housing unit and use the brush for cleaning.

  • Put the shaving heads back into the shaving units. Make sure the shaving head recess portion is aligned with the recessed locations.

  • Make sure the shaving head recess portion is aligned with the recessed locations.

  • Insert the flange of the shaving unit into the slot at the toacp of the shaver, then close the shaving unit.
    Note: if the shaving head units do not close smoothly, check the shaving head unit to make sure it is inserted correctly and the rack is locked.

Storage

Store with the protective cover on the shaving head to avoid damage.

Replacement

For the best shaving performance, we recommend replacing blades regularly. To replace the blades, follow the steps below:

  • Switch off the shaver.
    Unplug from the electricity supply.

  • Press the release button, and open the shaver head units.

  • Pull out the shaving blade parts from the shaver.

  • Tun the locking device (A) clockwise to remove the fixing rack (B).

  • Remove the shaving blades, and put the new ones into the shaving unit.

  • Make sure the shaving head recess potion is aligned with the recessed locations.

Environmental protection tips

When throwing away the product, please do not stack it together with other normal household waste. It should be handed over to an official designated recycling center that will be better for environmental protection.

Battery disposal
The built-in chargeable battery contains substances that may pollute the environment. When throwing away the shaver, the battery must be removed, then get it disposed at the official designated battery recycling center.

Remove the battery
To remove the battery out only when you discard the shaver and make sure the battery is completely depleted.
Detailed handling steps:

  • Disconnect the shaver from the electricity supply.
  • Switch on the shaver and run until all power is depleted.
  • Open the shaver head and unscrew the screws within the razor stubble storage compartment.
  • Remove the shell screw.
  • Remove the battery.
    Note: Do not connect the shaver with the electricity supply anymore after the battery was removed.

SAVE THESE INSTRUCTIONS

WARNING:
Detach the handheld part from the supply cord before cleaning it in water.

Suitable for cleaning under an open water tap.

BATTERY DISPOSAL

  • The battery must be removed from the appliance before it is Scrapper
  • The appliance must be disconnected from the supply mains when removing the battery;
  • The battery is to be disposed of safety;

WARNING
For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals