alocity F3D100 All-In-one Access Control Device User Guide

June 5, 2024
alocity

FCC ID: P27F3D100alocity F3D100 All In one Access Control
Device F3D100 All-in-one Access Control Device

Installation Prerequisite

Installation to be performed only by certiÞed installer!
Power Sourcing Requirement: PoE+ (802.3at Type 2) 30W!
Unit to be powered by UL294B certiÞed IEEE PoE+ 802.3at Type 2 Power Sourcing Equipment using unshielded cat5e or better cable with a maximum cable length of
330 feet (100 meters)!
A ULC 60839-11-1 Listed power supply with appropriate grade is required to be provided for ULC installations!
Wiegand/OSDP Badge Reader max cable length: 5 ft – 22 AWG (1.5 m)!
Wiegand Panel max cable length: 500 ft – 22 AWG (152 m), 300 ft – 24 AWG (91 m)
OSDP Panel max cable length: 4000 ft – 24 AWG (1,219 m),

Connect Directly to an Electric Lock

Fail Safe Lock
There is normally a current ßowing through the relay on the Fail-Safe lock. When the relay is activated, the current ßown is blocked, and the door lock will open. If the power supply is cut o” due to a power failure or an external factor, the door will remain open.alocity F3D100 All In one Access Control
Device - FIG

Connect the two NC wires together to the + wire on the lock. !
Connect the two COM (Brown/Red) wires to the + wire on the power source.!
Connect the – negative wire from the power source to the – negative on the lock.!
Each wire supports up to 1A, and connecting together will allow for up to 2A current to ßow.

Fail Secure Lock
There is no current ßowing through the relay on the Fail Secure lock. When the relay is activated, the current ßow is opened, and the door lock will open. If the power supply is cut o” due to a power failure or an external factor, the door will remain closed.

alocity F3D100 All In one Access Control Device - door

Connect the two NO wires together to the + wire on the lock. !
Connect the two COM (Brown/Red) wires to the + on the power source.!
Connect the – wire from the power source to the – on the lock.!
Each wire supports up to 1A, and connecting together will allow for up to 2A current to ßow.
Connect Power over Ethernet Cable (PoE)
The F3D100 uses 802.3at (PoE+).!
Connect a Cat5/6 ethernet cable to the RJ45 located on the pigtail of the F3D100.!
To setup a network connection use the Velocity setup app.!

Wiegand Input/Output Wiring Diagram

Wiegand

Output Wiegand 0| Green / Black
Output Wiegand 1| Orange / Balck
Input Wiegand 0| Burgundy / Blue
Input Wiegand 1| Brown / White
Ground| Black

OSDP Wiring Diagram

OSDP / RS485

RS485 A| Orange /White
RS485B| Green / White
Ground| Black

Input for Exit button & Door Contact Sensor Wiring Diagram

Inputs|
---|---
Input 1| Green / Yellow
Input 2| White
Ground| Brown / Yellow

Max number of face/templates enrolled shall not exceed 10,000!
Ethernet/PoE+ and Wiegand Cable to Reader and Panel are Class II/Power Limited!
Equipment not intended for connection to telephone, or outside wiring as covered by Article 800 in the National Electrical Code, NFPA 70!

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.!
CAUTION: Any changes or modiÞcations to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.!
CE Marking
Alcatraz AI hereby declares that these facial authentication devices are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.alocity F3D100 All In one Access Control Device -
SENSOR

Communication Interface
Ethernet PoE Wiegand IN/OUT OSDP/RS485 TTL Input Relay
Dimensions
Height: 6.80 inches Width: 2.70 inches Depth: 1.50 inches
Operating Temperature
-20°C – 50°C / -4°F – 122°F
Compliance
FCC, CE, ICESF
Authentication Methods
3D Face Recognition with Liveness Detection NFC/Mifare Contactless Card Mobile Credentials
Smart Card Technology
High Frequency 13.56 Mhz Mifare, NFC ISO 14442 A/B, ISO 18092 Compliant

Memory & Processor
Quad-core Arm® Cortex®-A53 up to 1 GHz
Image Signal Processor
Computer Vision processor for Deep Learning
3133 Commerce Parkway, Miramar FL 33025 •www.alocity.com

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals