Clarke TPG30P Airline Tyre Inflator User Guide

: June 5, 2024
: Clarke

Table of Contents

INTRODUCTION
GUARANTEE
SPECIFICATION
GENERAL SAFETY PRECAUTIONS
OPERATION
DECLARATION OF CONFORMITY
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

AIRLINE TYRE INFLATOR
MODEL NO: TPG30P
PART NO: 3082105
**USER INSTRUCTIONS
DL0122

**

INTRODUCTION

Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not affect your statutory rights.

SPECIFICATION

Weight	0.60 kg
Connecting Hose Length	400 mm
Max Working Pressure	8 bar/ 116 psi
Airline Connection size	1/4” BSP

GENERAL SAFETY PRECAUTIONS

Compressed air can be dangerous. Ensure that you are thoroughly familiar with all precautions relating to the use of compressors and a compressed air supply.
NEVER direct a jet of compressed air at people or animals.
ALWAYS ensure that the equipment/tool being used as a safe working pressure exceeds the output pressure of the compressor that it is connected to.
NEVER exceed the operating pressure stated in the specification.
ALWAYS ensure that the air supply is turned off at the tool outlet and vent all compressed air from the air hose and the equipment attached to it, before disconnecting air hoses or other equipment from your compressor.
Ensure all fixed air connections are properly sealed using Teflon tape or pipe sealant.
Check the gauge periodically for accuracy and replace it if damaged or inaccurate.

OPERATION

CAUTION: THIS PRODUCT MAY HAVE A LOWER WORKING PRESSURE THAN SOME COMPRESSORS WILL SUPPLY, THEREFORE, AN AIRLINE
A REGULATOR SHOULD BE INSTALLED.
CAUTION: AIRLINE LUBRICATORS SHOULD NOT BE USED WITH THIS ITEM

Under or over-inflated tyres are dangerous. Consult vehicle owners’ handbooks before using this tyre inflator.
Attach the airline hose to the tyre inflator and fully tighten it. Use PTFE tape if needed. Turn on the air supply and check that the airline pressure DOES NOT exceed 8 bar (116psi)

Remove the dust cap from the tyre valve and check that the tyre valve is clean before connecting.
Push the connector fully home onto the tyre valve. If the valve leaks, the connector may need repositioning. The correct position is confirmed by a steady reading on the gauge.
Check the tyre pressure on the gauge.
Pull the trigger to inflate the tyre. Re-check the tyre pressure. Note that when the trigger is pulled, the gauge will show the airline pressure, not the tyre pressure.
To deflate the tyre, partially pull the trigger and check the pressure again.
When the tyre pressure is correct, disconnect and remove the connector.
Replace the dust cap on the tyre valve.
IMPORTANT: The air pressure gauge on this product is for guidance only. It is important that you check the pressure with an approved, calibrated gauge.
Inspect the air hose for wear or damage periodically and replace it if necessary.
DO NOT use damaged or leaking hoses. Occasionally clean the product and lubricate the trigger parts.