Hager VME02SPD Surge Protection Kit Installation Guide
- June 5, 2024
- hager
Table of Contents
Hager VME02SPD Surge Protection Kit
-
Busbar
-
6mm sq earth cable
-
Type II Surge Protection
Move the main switch over 2 modules and clip the Surge protection device on the right hand side of the main switch.
Fit the 6mm earth cable into one of the terminals in the top of the SPD and terminate in the earth bar. Torque to 3.6Nm.
Loosen the bottom terminals on the Main switch and Surge protection device and
insert the busbar into the rectangle slots above the cage
terminals.
Push the busbar firmly against the Surge protection device making sure the
cables below are secure secure and torque back to
3.6Nm.
Replacement cartridges – SPB015, SPB015N
Fault indication
Documents / Resources
|
Hager VME02SPD Surge Protection
Kit
[pdf] Installation Guide
VME02SPD Surge Protection Kit, Surge Protection Kit, Protection Kit
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>