i3-TECHNOLOGIES CT1820 Wireless Streaming Station User Guide

i3-TECHNOLOGIES CT1820 Wireless Streaming Station

Connections and Indicators

Front Panel

1. Power Button

2. Network Activity Indicator (Green LED)

3. Power Status Indicator (Red/Blue LED)

4. USB 2.0 Type A

5. USB 3.0 Type A
   Rear Panel

6. HDMI Video Input

7. Ethernet LAN Port

8. HDMI Video Output

9. RS232 Port

10. 12V/2A DC Power Input

Setup

1. Power
   Connect the supplied AC adapter.

2. Display
   Connect using an HDMI cable.

3. Touchscreen and Mouse
   Connect using USB to enable touchscreen and/or mouse.

4. Network
   Your OnCollab Unit has to be connected to the same network as your device.

   • LAN Cable
     Simply connect a suitable ethernet cable from your network to the OnCollab Unit.

   • WI-FI
     Open the “System Settings” and you can choose which Wi-FI to connect to.

   • Hotspot
     Open the “System Settings” and then enable hotspot.

Power On

• Startup
  The OnCollab Unit starts automatically when power is applied.

• Standby Screen
  A normal default display screen is featured below for your reference.

Casting Your Screen

The OnCollab Unit supports three methods of screen casting.

• Native Casting
  Simply open either Airplay, Google Cast, or Miracast, find your OnCollab Unit there, and simply click to instantly cast your screen.

• Application
  Find your OnCollab Unit there, and simply click the “Cast Button” to instantly cast your screen.

• AT-C/AT-H
  Connect your AT-C/AT-H to your device. Once the lights turn white, simply touch the button to cast your screen.

Cloud Management System

• You can register your RX46 to our CMS using your browser.
• Once registered, you can manage your RX46 from anywhere, via our CMS portal.

Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interterence received, including interterence that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

RF exposure warning
This equipment must be installed and operated under provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>