GARRETT 1557400 Axiom Gold Detector User Guide
- June 4, 2024
- Garrett
Table of Contents
GARRETT 1557400 Axiom Gold Detector User Guide
ASSEMBLY
QUICK START
BATTERY CHARGING
ADJUSTING ARM CUFF
REGULATORY INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Wireless Transmitter Specifications
Audio Delay: 17 milliseconds
Audio Bandwidth: 30-18,000 Hz
Operating Frequency: 24062474 MHz
Transmit Power: 8.6 dBm EIRP
Certifications: FCC, CE, IC, AS/NZ
CONTROLS
- Power and Factory Reset– Hold 1 second for power ON or OFF. Press and hold 5 seconds to restore Factory Settings. Tap to exit MENU settings.
- VOLUME Plus/Minus buttons– Use to increase / decrease detector volume.
- SENSITIVITY Plus/Minus buttons– Use to increase / decrease Sensitivity setting. These buttons are also used while adjusting MENU settings.
- MENU/Iron Check– Repeatedly press to scroll through Menu items, then use the Plus (+) or Minus (-) buttons above MENU to change setting. Press and hold button to use Iron Check function.
- THRESHOLD Plus/Minus– Use to adjust the background audio hum that is added to target response.
- Ground Balance– Hold down while bouncing coil above ground until ground response disappears or becomes as small as possible.
LCD/DISPLAY ELEMENTS
- Signal Strength Indicator– indicates both signal strength and polarity.
- Iron Check– Indicates that Axiom’s Iron Check feature is in use.
- Mode– Select from Fine, Normal, Large or Salt.
- Frequency Scan– To overcome EMI, highlight FREQ SCAN on Menu, and press Plus (+) Menu button to begin the scan. Takes approximately 45 seconds.
- Tone– Scroll through 00 to 99 to select your preferred audio tone.
- Audio Type– Select 00 for PWM audio or 01 for VCO audio..
- Sensitivity– Indicates current Sensitivity setting.
- Battery Level– Shows status of battery life (25% per segment).
- Speed– Select Slow, Medium or Fast detection speed.
- . Ground Track– Select Off, Slow, Medium or Fast continuous ground tracking speeds.
- Backlight– Indicates LCD Backlight is on.
- Wireless headphones– Press Plus (+) Menu button to pair to headphones or Minus (-) to unpair. Icon flashes while attempting to pair; is solid when unit is paired with headphones.
- Gnd Balance Arrows– Indicates trending direction of ground balance when Gnd Track is on.
- Gnd Balance Indicator– Displays while performing ground balance.
- Ground Balance Values– are shown by the upper and lower 2-digit numbers.
FACTORY DEFAULT SETTINGS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>