Shenzhen Apexel Technology K1 Wireless Microphone User Manual
- June 4, 2024
- Shenzhen Apexel Technology
Table of Contents
Shenzhen Apexel Technology K1 Wireless Microphone
Introduction
Thanks for choosing our product. This product is a smart wireless microphone
that provides professional-grade recording output. Plug and play, no app
required. Multiple uses: It can be used in nouned live broadcast, video Vlog
shooting, program interview,
recording, video teaching and other occasions. The wireless Microphone
consists of 13No parts, one is Microphone transmitter , the other one is
receiver.
(see as below picture)
ID Diagram
- Windproof net
- Microphone clip
- Switch key
- port to connect phone
- Receiver indicator
- Reset key of receiver
- port to connect phone
- Receiver indicator
- Reset key of receiver
How to use
Step 1: connect the receiver to phone with port.
Note: oppo / vivo/ iqoo / realm brand mobile phones can be used normally only when they go to the settings (search ‘OTG” – turn on OTG power supply)
Step 2: Press switch key of microphone, the indicator Light turns green, and then power is turned on.
Step 3: The indicator red Light of receiver keeps always on, then open the phone camera, live App or other Apps, and then to use the microphone to receive sound.
Special Note:
For the use of port : there is no battery in receiver, and no need to
recharge during live. If the phone is low power during Live, it can be
recharged directly through port.
About UI
Microphone Transmitter
Receiver
Packing List
content of packing
- Microphone transmitter
- Receiver
- Charging cable
- User manual
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.