Outsunny 84C-502V00 3x3m Pop Up Gazebo Instruction Manual

Outsunny 84C-502V00 3x3m Pop Up Gazebo

Product Information

Specifications

• Model: IN230900551V01_GL
• Part Number: 84C-502V00

Product Usage Instructions

Step 1: Assembly

Refer to the assembly diagram provided in the manual to correctly assemble the product parts.

Step 2: Power On

Connect the product to a power source and switch it on using the designated power button.

Step 3: Setting Up

Follow the on-screen instructions or refer to the user manual to set up the product according to your preferences.

Step 4: Operation

Use the control panel or remote control to operate the product functions as needed.

Step 5: Maintenance

Regularly clean and maintain the product as per the maintenance guidelines provided in the manual to ensure longevity and optimal performance.

Frequently Asked Questions

Q: How do I troubleshoot if the product is not turning on?

A: Check the power source, connections, and ensure the power button is functioning properly. If issues persist, refer to the troubleshooting section in the manual or contact customer support.

Q:Can I use the product outdoors?

A: This product is designed for indoor use only. Using it outdoors may damage the product and void the warranty.

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

Dear customer,
Thank you for purchasing this product. So that your appliance serves you well, please read all the instructions in this user’s manual. If you have any questions, please contact our customer care center.Our contact details are below:

• Country
  US

• Phone
  001-877-644-9366

• Email
  customerservice@aosom.com

WARNING

1. Find a flat and stable surface large enough to set up the folding pavilion. Carefully take the tent frame out of the bag and place it on a dry surface (sand, grass or firm surface).
2. Follow these instructions carefully to avoid getting your hands and fingers caught in the moving parts of the frame when opening and closing the frame. You need at least two people to safely assemble and dismantle the folding pavilion. Do not try to set up the tent by yourself, as pulling on one side can overload the tent legs and damage them unnecessarily. To avoid damage, the tent must be pulled out in tandem.
3. In windy conditions, secure the tent using the ropes attached to each side of the canopy. Attach the ropes to the pegs at a 30 degree angle and anchor them to the ground with a hammer. If the canopy is placed on a hard surface, secure the 4 sides with bricks or sandbags.
4. Do not set up the pavilion in windy weather conditions. This can lead to injuries and/ or damage to your tent.
5. Do not use chemical additives to clean the roofs and side walls. The water temperature can be a maximum of 30°C.
6. Make sure that you pack the folding tent dry and store it upright in the bag provided in a dry place. A damp tent can get mold stains.
7. No liability is accepted for damage caused by improper storage or cleaning.
8. Please take appropriate actions as heavy rain, wind and snow can damage the tent. If necessary please dis -assemble and store for later use.
9. In snowy conditions please do not allow the thickness of the snow to be more than 5cm on the roof, this should be cleared as soon as possible for your safety.

PARTS

INSTALLATION

1. Erect the frame and half-open it.

2. Place the canopy fabric on the frame and align the four corners of the canopy fabric with the four corners of the frame.

3. Attach the canopy fabric to the frame with the loop fasteners. Push up the central locking system until it locks into place and the entire frame is fully extended. After setting up the canopy fabric. Please reinforce the fabric to the frame with the loop fasteners inside the canopy.

4. 3 holes on each leg for 3 adjustable heights. Adjust the canopy height by pushing the spring buttons and sliding the telescopic outer tubes along the legs.
   Note: Push the spring button till the outer tube of the leg is movable, then release the button. Extend the telescopic legs to your desired height and the button will automatically lock in place. Please do not overextend the frame legs, otherwise the canopy fabric may be damaged.

5. Fill up the sand bags and tie them to the frame legs.Connect the canopy fabric and the ground anchors with ropes, and fix the anchors into the ground for added stability.

US
Imported by Aosom LLC
27150 SW Kinsman Rd Wilsonville, OR 97070 USA
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>