Elevation 0047361 Mini Continuous Hand Towel Instruction Manual
- June 1, 2024
- Elevation
Table of Contents
Elevation 0047361 Mini Continuous Hand Towel
Tork PeakServe® Mini Continuous™ Hand Towel Dispenser
The image shows a Tork PeakServe® Mini Continuous™ Hand Towel Dispenser. It is part of the Elevation Design series and is designed for dispensing continuous hand towels.
Specifications
| Product | Tork PeakServe® Mini Continuous™ Hand Towel Dispenser |
|---|---|
| Design | Elevation Design |
| Installation | Wall-mounted |
| URL | www.torkusa.com |
Installation Instructions
- Using a level, mark the wall at the height of 60 inches from the ground to align the dispenser properly.
- Drill holes in the marked positions, insert wall plugs, and secure the mounting bracket to the wall with screws.
- Hang the dispenser on the mounting bracket and slide it down to lock in place.
- Open the dispenser by pressing the button on the bottom and pulling the cover towards you.
- Load the hand towels into the dispenser, making sure to follow the indicated direction for proper dispensing.
- Close the dispenser cover securely.
- Use the dispenser by pulling the towels from the bottom.
Care and Maintenance
Dispensers should be dusted with a soft, lint-free cloth. Do not use abrasive materials or paper as they will scratch the surface. For cleaning, use a clean, damp cloth, or a solution of mild soap and water. At least once per month it is recommended to remove paper dust from inside the dispenser with a vacuum or compressed air. Always wear eye protection when using compressed air.
Warning
- To avoid a potential shock hazard to dispenser users, do not install dispenser directly above an electrical outlet or within six inches from any edge of an electrical outlet.
- Do not place the dispenser in a position where users must reach over an electrical outlet to access the dispenser.
- It is the installer’s responsibility to ensure installation of the unit complies with all applicable codes, standards, and regulatory requirements including building codes and electrical codes.
Disposal
Damaged or malfunctioning product should be disposed of immediately to avoid potential injury. Products should be disposed of in accordance with applicable regulations.
FAQ
What is the proper way to clean the Tork PeakServe® Mini dispenser? Use a soft, damp cloth with mild soap and water to clean the dispenser. Avoid abrasive materials to prevent scratching the surface. How often should the dispenser be cleaned? It is recommended to dust the dispenser regularly and perform a more thorough cleaning at least once per month. What should be done if the dispenser is damaged or malfunctioning? Immediately dispose of the dispenser to prevent injury and replace it if necessary. Follow local regulations for disposal of such products. Are there any installation precautions? Yes, ensure the dispenser is not installed directly above or within six inches of an electrical outlet to avoid shock hazards. Comply with all building and electrical codes.
Manufacturer Information
Manufactured for Essity Professional Hygiene North America LLC located in Philadelphia, Pennsylvania 19103. The website for the manufacturer is www.torkusa.com, and the product is made in Poland.
CONTANTS
INSTALLATION
Manufactured for
Essity Professional Hygiene North America LLC
Philadelphia Pennsylvania 19104
www.essity.com,
www.torkusa.com
Made in Poland
Patents/Brevets/Patentes: www.essity.com/patents
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>