Bespoke DW60CB750FAP Dishwasher Panel Instruction Manual

Bespoke DW60CB750FAP Dishwasher Panel

Product Information

Specifications:

• Model: DW60CB750FAP Dishwasher
• Custom Panel Options: DW-S24PEU39 Beige Panel, DW-S24PEUB0 Black Panel
• Number of Holes for Panel Installation: 6

Product Usage Instructions

Installing the Custom Front Panel:

1. Open the dishwasher door.
2. Fit the custom panel in the front bottom of the door, ensuring the ribs align with the corresponding holes on the door (6 holes in total).
3. Hold the door and the custom panel with both hands, then press the panel evenly from bottom to top to lock it into place.
4. Once both sides of the panel are locked in, press the top centre of the custom panel to secure it to the top of the door.
5. If the gap between the dishwasher and the custom panel is below 2 mm, installation is correct. If it’s 2 mm or more, remove and re-install the custom panel.
6. Unpack the caps and screws included in the product package (two screws for each side). Tighten the screws on either side of the dishwasher, checking for proper alignment.
7. Insert the caps on either side, ensuring the rib of the cap fits into the hole of the dishwasher correctly.
8. Completion: The custom panel is now mounted securely.

FAQ

• Q: What should I do if the custom panel does not fit properly?
  A: If there is a gap of 2 mm or more between the dishwasher and the custom panel, remove the panel and try re-installing it following the instructions carefully.

• Q: How many holes are there for installing the custom panel?
  A: There are a total of 6 holes for installing the custom front panel on the dishwasher door.

What you’ll need

Installation

1. Open the door and fi t the custom panel in the front bottom of the door. Make sure that the ribs of the panel fi t into the corresponding holes (totalling 6) of the door.

2. While holding the door and the custom panel with both hands, press the panel evenly from bottom to top to lock into the dishwasher.

3. When both sides of the panel lock into place, press the top centre of the custom panel to secure it to the top of the door.
   NOTE:
   Make sure that the custom panel fi ts in the dishwasher properly. If the gap between the dishwasher and the custom panel is below 2 mm, proper installation is done. For 2 mm or more, remove the custom panel and try again.

4. Unpack the caps and screws (two for each) included in the product package. Tighten the screws on either side of the dishwasher.
   NOTE: When tightening the screw on either side, make sure to check the gap between either side as the custom door may lean in either side.

5. Insert the caps on either side. Make sure the rib of the cap fi ts in the hole of the dishwasher in the right direction.

6. This is the completion of mounting the custom panel.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>