EURO POLE 67010 Europole Light Gray 15W Instruction Manual

EURO POLE 67010 Europole Light Gray 15W

INSTRUCTION MANUAL

ELIOS SOLAR 8,5W & 15W

CODES : 67010 – 67110 – 67020 – 67120

WARNING: The installation must be carried out by qualified persons in accordance with the standards and regulations in force. It is recalled that the decision to install the products in an environment compatible and in compliance with the standards and good practices is the full responsibility of the buyer and the installer. Read and follow the instructions before installing or using the products. We do not accept any liability resulting from improper implementation or installation of the products.

The devices must not be modified, even partially, otherwise the warranty will not apply.

1. TECHNICAL SPECIFICATIONS

Operating temperatures: 0°C à +45°C
Infrared sensor detection distance: 9m
Twilight sensor activation: 20-30 lux

2. PRE-INSTALLATION PRECAUTIONS

Open the package and check the contents carefully. If there is any damage, return the products to the seller. Do not attempt to handle a damaged product.
Let an electrician or someone with electrical accreditation install, remove or repair the floodlight.
Do not touch the infrared sensor lens with a sharp or pointed object.

3. DETECTION

Detection takes place via an infrared sensor over a distance of 9m.

4. INSTALLATION

Press button 1, which is at the back of the floodlight, before installing it.

Use the drill holes and locking screws on the base unit (Allen key no. 6) to adjust the orientation of the light.

Screw to lock the device.

Install the solar-powered floodlight facing towards the sun. Make sure that the solar panels are not covered.

The floodlight is fitted with a twilight sensor (20-30 lux). It must not be installed near another light source.
Drill two holes in the wall at a distance of 70-90mm for 8.5W and 110-150mm for 15W. Fix the floodlight onto the wall using screws and nuts (not provided).

5. FEATURES

The floodlight must be charged for a whole day before being used for the first time.

The floodlight can be adjusted using the remote control supplied.

When the floodlight is adjusted during the day: select the required function on the remote control. The floodlight lights up to check that it is properly installed. Then press OFF on the remote control. The floodlight remembers the function chosen for use at night.

When the floodlight is adjusted at night: simply select the required function on the remote control.

| ON: Switches on the floodlight in continuous mode.
---|---
| OFF: Switches off the floodlight.
| « – »: reduces the luminous intensity down to 5%
| « + »: increases the luminous intensity up to 100%
| Detection mode: Lighting at 100% luminous intensity for 30 seconds if etection then switches off
| Detection mode +10%: Lighting at 100% luminous intensity for 30 seconds if detection then remains lit at 10%
| 2-hour mode: Lighting for 2 hours at 100% luminous intensity then switches off
| 2-hour mode then detection: Lighting for 2 hours at 30% luminous intensity then switches to detection mode (lighting at 30% luminous intensity for 30 seconds if detection then switches off
| hour mode: Lighting for 4 hours at 50% luminous intensity then switches off
| hour mode then detection: Lighting for 4 hours at 10% brightness then switches to detection mode (lighting at 10% brightness for 30 seconds if detection then switches off)

The last setting remains in the memory if the floodlight is switched off.

6. MAINTENANCE

Clean the glass and the solar panel regularly to keep the floodlight in good condition. Clean the case regu-larly to maintain good heat dissipation. Do not use water or corrosive products for cleaning; use a dry cloth. If the floodlight is not used, ensure that the battery is charged regularly to preserve its qualities.

7. CHANGING THE BATTERY

Reference for the replaceable battery:

For the 8.5W floodlight: ref 6781 – battery Li-ion 6000mAh, 3,7VDC
For the 15W floodlight: ref 6782 – battery Li-ion 12000mAh, 3,7VDC

1. Uninstall the floodlight and turn the rear switch to 0.

2. Undo the screws of the battery compartment at the back of the device (Torx key no. 10).

3. Disconnect the battery connector and remove it.

4. Attach the new battery connector and place the battery in the compartment.

5. Screw down the lid of the battery compartment.

6. Press button 1, which is at the back of the floodlight, before installing it.

8. INSTALLATION OF THE ADJUSTABLE YOKE MOUNT

Accessory to be ordered separately.

For the 8.5W floodlight: ref 6791 (anthracite grey) or 6801 (light grey).
For the 15W floodlight: ref 6792 (anthracite grey) or 6802 (light grey).

1. Unscrew the existing yoke mount on the product (Allen key no. 6).

2. Screw the adjustable yoke mount in place (Allen key no. 6).

3. Drill two holes in the wall at a distance of 70-90mm for 8.5W and 110-150mm for 15W.

Fix the floodlight onto the wall using screws and nuts (not provided).

9.SOLAR PANEL OFFSET INSTALLATION KIT

Accessory to be ordered separately.

For the 8.5W floodlight: ref 6710 (anthracite grey) or 6711 (light grey).

For the 15W floodlight: ref 6720 (anthracite grey) or 6721 (light grey).

The solar panel can be offset if the floodlight is not installed facing towards the sun.

Note: the battery must be disconnected before cutting the cable.

1. Turn the rear switch to 0.

2. Undo the screws of the battery compartment at the back of the device (Torx key no. 10).

3. Disconnect the battery connector.

4. Cut the cable that runs between the 2 parts of the floodlight.

5. Separate the 2 parts of the floodlight by unscrewing the nuts (Allen key no. 4).

6. Fix the yoke mount provided in the kit onto the solar panel (Allen key no. 6).

7. Unscrew and separate the male and female parts of a watertight connector (provided). Connect the male part to the cut projector cable and the female part to the 4m cable, respecting the colours of the strands (Black=1, Blue=2, Brown=3, Yellow/Green=earth).

8. Screw up the connector. Carry out the same steps for the second connector and the solar panel component.

9. Connect the battery and close the compartment.

10. Secure the products as indicated in paragraph 4. INSTALLATION

10. INSTALLATION OF THE GROUND STAKE

Accessory to be ordered separately.
For the 8.5W floodlight: ref 6199.

1. Unscrew the existing yoke mount on the product (Allen key no. 6). Retain the screws and two washers.

2. Take the largest yoke mount provided in the box. Screw the yoke mount onto the stake (washer and nut).

3. Position the ground stake at the back of the floodlight. Position the washers and screws then fasten (Allen key no. 6).

4. Screw the pointed connector onto the stake.

NOTICE D’INSTALLATION EUROPOLE – n°327 – V1 – 26/10/2023 – ELIOS SOLAR 8,5W & 15W
EUROPOLE – 19, avenue ZAC de Chassagne – 69360 TERNAY – Tél. : +33 (0)4 72 49 80 49 – Fax : +33 (0)4 72 24 73 42 – www.europole.net

Specifications

• Model: ELIOS SOLAR 8,5W & 15W

• Codes: 67010, 67110, 67020, 67120

• Power Options: 8.5W, 15W

• Languages: FR, EN, NL

FAQ

Q: How do I adjust the illumination angle of the lamp and solar panel?

A: Use the drill holes and locking screws on the base unit to adjust the orientation of the light and solar panel accordingly.

References

• Accueil

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>