Ausanat AN-H50 Ultrasonic Humidifier User Manual
- June 10, 2024
- Ausanat
Table of Contents
AN-H50
Ultrasonic Humidifier
User Manual
AN-H50 Ultrasonic Humidifier
Get 24/7 Assistance at
Or Visit: https://ausanat.afterservice.vip
ausanat@afterservice.vip
NOTE: Please take notice of below instructions and the separately included warning sheet before using the product.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
Installation
- Please do not set up the device in a place where humidity directly hits curtains, furniture, indoor plants or doors. It can cause stains and deformation.
- Please place the device on a horizontal and stable surface, otherwise it might be a risk of water spilling.
- Please do not set up the device in a place where only children are present such as children’s room. It can lead to injury or breakdown if the device is knocked over or climbed on.
- Please do not place the device anywhere where it may fall from above. It can lead to ignition or a breakdown.
- Please do not set up the device near devices that are not compatible with water such as PCs or smartphones. It can cause ignition or a breakdown.
- Please do not use up the device in any surrounding that could lead to the water in the water tray or in the device to freeze. However, if the water in the water tray or the device is frozen please do not operate the device until the ice has thawed. It can cause ignition or a breakdown.
Placement
Please place the device away from walls, window and furniture.
- Even when it is placed at a sufficient distance from walls or furniture, if it is used in the same place for a long period of time, it can become dirty with scale. We recommend regular cleaning. Please refer to maintenance instructions.
- Please avoid placing the device under direct sunlight.
- If there is interference with TV, radio or other electrical devices, please move the device.
- When moving the device, please hold the base of the device carefully.
- A comfortable humidity level is between 40-60%. If you notice condensation on the walls or windows you should turn off your humidifier as the humidity level is too high.
Filling the water tank
-
Pour the water slowly from the top.
-
·Remove the cover, then fill the water tank.
·Please do not fill water exceeding the max water line marked in the main body.
·Please try to fill water slowly. And do not pour water into the air outlet and mist pipe. This will cause the mist to stop. If there is water in the mist pipe, remove the mist pipe and drain and try again. -
Remove the water tank from the base. Fill the water tank under the tap directly. Do not pour water into the air outlet and mist pipe.
Operation
Plug the power cable into the power socket of the device, and insert the AC plug firmly into the outlet.
Control panel and function
| Power indicator light | Power | |
|---|---|---|
| Timer indicator light | Timer | |
| Mist volume indicator light | Mist volume |
Power button
When connecting the power, the power indicator light will turn red, and the
device will be standby. Touch the button, the device will be turned on/off.
Timer button (2/4/6hours)
When you touch the timer button for the 1st time, the timer will be set 2
hours. When you touch the button for the 2nd time, it will be set 4 hours.
When you touch the button for the 3rd time, it will be set 6 hours. Each time
you touch the setting button, the display of humidifier indicator light is as
below.
Mist volume setting button
The mist volume can be set in three-stage: about 120(low) /170(medium) /
220(high) ml/h. Each time you touch the setting button, the display of
humidifier indicator light is as below.
Remote control
The device also synchronizes with the remote control when operating the speed,
timer and switching the device on and off.
Remote control for 2.4 g induction, 360 degrees operation and remote operation
(more than 10 meters).
Display
15s without operation, remote Control will automatically light off, and you
can press the button to light up the screen.
Displayed on the remote control are synchronized with the contents displayed
on the device.
Power button
When connecting the power, the power indicator light will turn red, and the
device will be standby. Touch the button, the device will be turned on/off.
Timer button (2/4/6hours)
You set 2/4/6 hours by pressing the timer button, in the same time, the
display will show: 2/4/6.
Mist volume setting button
The default speed is low speed, press the button to cycle with five indicators
per speed (low, medium, high).
Auto button
Press the auto button, the device will adjust automatically according to
humidity.
Temp. Switch button
Long press the temp. switch button for 3s to switch the temperature.
The device can be turned off by the switch button to see the current
temperature and humidity.
How to add the aroma
Hold on the handle of the aroma tray, and then remove the aroma tray.
Drop 1~2 drops onto the aroma cotton.
Specification
Size: 322280153mm
Weight: 2.2kg
Main materials: HIPS, ABS, GPPS, PP
Voltage: AC100~240V 50/60Hz
Power consumption: 22W
Water tank capacity: 5L
Mist output: 220ml/h Max
Timer: 2/4/6 hours
Manufacturer information
Manufacturer: Guangdong Mixwell Technology Co., Ltd.
Address: 1-4#F, A Building, NO.7 Yu Hua Street, 138 Industrial Area,
Tangxia, Dongguan, China
Disclaimer
Thank you for purchasing our product! By using this product, you hereby
signify that you have read the Disclaimer and all warnings carefully and that
you understand and agree to abide by the terms and conditions herein. The user
should observe safe and lawful practices including, but not limited to, those
set forth in this document. Our company therefore holds no liability for
damages caused by force majeure, used by a third party, incorrect use, non-
compliance with this user manual or intentional misconduct on the part of the
user.
Except for the scope prohibited by the applicable laws, the company is not
responsible for any incidental, indirect, special or consequential damages,
including but not limited to the loss of profits, income or data due to the
violation of explicit or implied warranties or conditions mentioned in this
user manual.
Information in this user manual is for informational purposes only. It is
subject to change without prior notice, due to the manufacturer’s continuous
development program. This document supersedes and replaces all information
supplied prior to the publication hereof.
Warranty
We warrants all products to be of the highest quality in material,
craftsmanship, and service. It is effective starting from the date of
purchase.
We will replace any product found to be defective due to manufacturer flaws
based on eligibility. Refunds are only available to the original purchaser of
the product. This warranty extends only to personal use and does not extend to
any product that has been used for commercial, rental, or any other use in
which the product is not intended for. There are no warranties other than the
warranties expressly set forth with each product.
This warranty is non-transferrable. We are not responsible in any way for any
damages, losses or inconveniences caused by equipment failure or by user
negligence, abuse, or use noncompliant with the user manual or any additional
safety, use, or warnings included in the product packaging and manual.
This warranty does not apply to the following:
- Damage due to abuse, accident, alteration, misuse, tampering or vandalism.
- Improper or inadequate maintenance.
- Damage in return transit.
- Unsupervised use by children under 18 years of age.
we assume no liability for damage caused by the use of the product other than for its intended use or as instructed in the user manual. Some states do not allow this exclusion or limitation of incidental or consequential losses so the foregoing disclaimer may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state.
RF Exposure The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Get 24/7 Assistance at Or Visit: https://ausanat.afterservice.vip
ausanat@afterservice.vip 
MADE IN CHINA