Venen Engel 6 Mobile Massager Instruction Manual
- June 1, 2024
- Venen Engel
Table of Contents
- PRELIMINARY REMARK
- BEFORE YOU GET STARTED
- STEP 1: BEFORE USE
- STEP 2: OPERATION
- STEP 3: ENJOY THE MESSAGE
- STEP 4: STOPPING AND DISASSEMBLY
- TROUBLESHOOTING
- Instruction for Accessories
- CONTENT & TECHNICAL DETAILS
- SAFETY INSTRUCTIONS
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Venen Engel 6 Mobile Massager Instruction Manual
PRELIMINARY REMARK
Congratulations on the purchase of this device! You will enjoy your Venen
Engel very much! If you are satisfied with your Venen Engel, we would be very
pleased if you submitted a review.
This guide includes details that should be taken into account by the user, to
avoid risks, and to enable the safe use of the device.
Should you have any questions about its application, its accessories, or if
you have suggestions, please do not hesitate to contact us! We are also happy
to help you with any complications that develop during or after using the
product.
BEFORE YOU GET STARTED
- Please read the operating instructions carefully before using the device.
- Keep this user manual so you can consult it, if necessary.
- Venen Engel may not be used if you suffer from certain health conditions. Please read the list of contraindications carefully on last page
STEP 1: BEFORE USE
CONNECT THE HOSE SET AND CUFFS
Connect the tubes to the connectors on the cuffs. Make sure the longest tube
goes to the foot air chamber.
Note: We recommend that you do not detach the connectors after setup
CONNECT THE TUBE SET AND THE CONTROL UNIT
There are two clips on the side of the multi-plug. Depress the clips then
insert the multi-plug into the control unit
Note: Please insert the small fittings of the multi-plug into the
openings found above the air outlets.
CONNECT THE POWER SUPPLY TO THE CONTROL UNIT
Connect the power supply to both the control unit and an outlet to ensure power
Note: To keep the device clean, we recommend wearing thin jogging pants or leggings. Keep pockets empty. Zip the cuffs completely closed to avoid sudden opening. Be careful not to kink the tubing during use.
STEP 2: OPERATION
STEP 3: ENJOY THE MESSAGE
MESSAGE PROGRAMS A-D :
The air chambers in the leg cuffs are filled based on the selected program.
This creates an optimal and relaxing gliding pressure message on both legs.
Duration and pressure, in addition to optional additional functions can also
be adjusted during the message.
STEP 4: STOPPING AND DISASSEMBLY
After the set time has elapsed or after pressing the off switch, remove the
multi-plug from the device. If you don’t feel well
during the message, you can switch the system off at any time. Once turned
off, you can open the cuffs. To quickly deflate the air chambers after use,
press on the air chambers with both hands. The gray tube cuff connectors can
be left permanently connected. For storage, place the cuffs (incl. tubes) on
top of each other. Then roll them loosely together. The cuffs can be cleaned
using a damp cloth and mild detergent. Allow the cuffs to dry thoroughly.
Disinfectants such as Descosept pur or comparable products with a
similarcomposition are suitable for disinfecting the cuffs.
TROUBLESHOOTING
AIR IS ESCAPING (AUDIBLY)
- Check the tubes and connectors for damage or kinks that could cause air to be trapped.
- Make sure the multi-plug is seated correctly in the control unit.
THE CUFFS INFLATE IN THE WRONG ORDER
- Make sure the multi-plug is inserted in the control unit using the correct orientation. The multi-plug is seated correctly if the small fittings of the multi-plug are in the openings found above the air outlets.
I HAVE A LEG / ABDOMEN SET AND WISH TO USE ONLY THE LEG OR ABDOMEN CUFFS THIS TIME
lf you would like to use your Vein Angel in a different configuration than the one that was shipped to you, you will need the appropriate hose set. All hose sets are available in our online shop. lf you need help selecting a set, please contact us! We will be happy to help you
THE DEVICE PUMPS AIR, BUT NEITHER OR ONLY ONE OF THE CUFFS IS INFLATING
lf, after starting the programme, you find that not all the sections are
filling with air, please check (1) if the multi-plug is correctly inserted
into the control ler. Also check that (2) the air hoses are not kinked and
that you are not sitting on any of them. Finally, check (3) that that the
plugs in the cuffs are all proper ly inserted.
Instruction for Accessories
**ATTACHING THE EXTENSION FLOP
PUTTING ON THE ARM CUFF**
**Step 1
Step 2
Velcro the strap to the back of the cuff.
Step 3
Step 4
Pull the cuff onto your arm and make sure the end is sitting on your
shoulder. Run the strap under your other arm and attach it to the front of the
cuff.**
PLACEMENT OF THE ABDOMEN CUFF
The bottom of the cuff should sit directly against the top of the leg cuffs.
Tip: put on the leg cuffs first. Then place the abdomen cuff behind you on the
ground (inside facing up). Lay yourself back onto the cuff. Once you have
adjusted it to the correct height, zip it around your stomach.
COMBINING PIECES
lf you would like to use additional cuffs, make sure you pay attention to the
number of air chambers in each one as you buy them. lf you would like to use
the additional cuffs in combination with the ones you have, you will need the
appropriate hose set.
CONTENT & TECHNICAL DETAILS
**Device
Power plug
Cuffs
Multi-Plug air hose set
**
Number of programmes | 4 |
---|---|
Number of air chambers | 6 |
Weight (in kg] | -1,6 |
Power output (in WI | 35 |
Mains frequency (in Hz) | 50 / 60 |
Voltage (in V] | AC110-240 |
Timer setting (in min] | 5-99 |
Pump output (in I/min] | 12 |
Pressure (in mmHg] | 30-240 |
Dimensions (in cm) | 22x 14 x9 |
Protection class | Ill |
Temperature range [in ‘CI (use and storage) | 10-40 |
Humidity (in %j (use and storage) | 30-85 |
Battery:
- Charging time / running time (in min)
- Type·
- Model number·
- Voltage·
- Capacity·
- Stored current
| 130 /180 Li-ion Acti 18650 11.1V Go tc 5000 mAh
55.5 Wh
SAFETY INSTRUCTIONS
Keep these operating instructions in a safe place! Do not disassemble or burn the unit. Repairs to the control unit may only be carried out by specialists authorised by Wellcosan GmbH, otherwise the warranty may be voided. In case of damage to the unit, pull out the mains plug and switch off the unit. Also disconnect the mains plug and switch it off if the unit has come into contact with water or other liquids. Do not use the unit in damp rooms. Ensure that the unit is standing securely. Do not subject the device to shocks or throw them. The unit must not be covered by other objects during operation. Make sure that the hoses do not twist or kink during use and storage. Keep the unit away from sources of heat (e.g. direct sunlight, radiators and others). When you are not using the unit, the unit must be switched off. The unit switches itself off after 10 minutes of inactivity. When not in use also unplug the appliance from the mains. Always unplug the appliance from the mains before cleaning. Keep the product away from children or persons who have not been instructed in its use
With the CE marking, the manufacturer or importer confirms the conformity of the product with the applicable EC directives and compliance with the “essential requirements” specified therein.
This marking on the unit means that you must not dispose of it in normal household waste at the end of its service life. Please have it disposed of by an electronic waste disposal company.
The abbreviation UKCA stands for UK Conformity Assessed. The marking is a prerequisite for the marketing of products within Great Britain.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>