NERF BOARD NBT07CC-TX Running Board Instruction Manual
- June 13, 2024
- NERF BOARD
Table of Contents
**NERF BOARD NBT07CC-TX Running Board Instruction Manual
**
| HWKT-03054X | QTY |
|---|---|
| FLBW-00894X | M8-1.25 X 30MM FLANGE CAPSCREW W/WASHER |
| HWKT-09617X | QTY |
| --- | --- |
| BHCS-09591X | M6X16MM BUTTON HEAD CAP SCREW |
| FW-09601 | M6 FLAT WASHER |
| BHCS-09603 | M6 flanged nut |
| CARB-09609 | 3/8″-16X1″ Gr 5 Steel Carriage Bolt |
| HXNT-09613 | 3/8″-16 HEX NUT |
| FW-09611 | 3/8″ FLAT WASHER |
| PARTS INCLUDED | QTY |
| --- | --- |
| Driver Side Running Board | 1 |
| Passenger Side Running Board | 1 |
| Rocker panel brackets | 6 |
| Step Plate | 4 |
Installation
Step 1: Identify Driver Side Nerf Board.
Step 2: Install the supplied step plate (x2) to each Running Board using
the M6x20mm button head bolts, M6 nuts and M6 flat washer.
** DO NOT OVER TIGHTEN **
Step 3: Install the supplied rocker panel brackets (x6) to the
attachments points located on the backside of the main tube (Driver/Passg)
using the supplied 3/8” x 1” carriage bolts and 3/8” flanged nuts. Leave
finger tight for now.
NOTE: BE SURE THE BEND DIRECTION OF EACH BRACKET IS CORRECT ON THE DRIVER
AND PASSENGER Nerf Board.
Step 4: Remove any factory hardware and discard.
Step 5: Carefully raise the Nerf Board up and match the brackets with the
factory mounting locations. Next, starting with the center bracket and using
the supplied M8X30mm Hex cap with washer, start and leave loose.
Step 6: Start the remaining hardware with the front and rear bracket and
then tighten (18-20 ft./lbs.)
Step 7: There will be ½” of adjustment in the (x3) mounting bracket. Adjust to desired position and tighten to (20 ft,/lbs).
Step 8: Repeat steps 4-7 for passenger side.
12302 Shiloh Church Rd. Houston TX 77066 Phone 281-880-6322 – Fax 281-880-6325
I-SHEET PART NUMBER: INST-00237
PART NUMBER: NBT07CC-TX
PRODUCT: NERF BOARD
APPLICATION: 07-21 TUNDRA CC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>