MoerLab 2A8MIAH185 MOOR Talkie Bluetooth Auracast Wireless Earbuds User Manual

MoerLab 2A8MIAH185 MOOR Talkie Bluetooth Auracast Wireless Earbuds

What’s in the box?

• Charging case *l
• Talkie Buds earbuds *2
• Type-C charging cable*l
• Eartips*6
• User manual*l

OVERVIEW

POWER ON

• Open the charging case, and the earbuds will automatically power on.
• To power on manually, tap and hold the touch area of the earbuds for 2 seconds ( when powered off).

POWER OFF

• Put the earbuds in the charging case and close the case lid, the earbuds will automatically power off. (When earbuds are in pairing mode with each other, though you put one earbud into the case, the other one will not turn off and can still be used).
• To manually power off, tap and hold the touch area of the earbuds far 8 seconds (when powered on).
• No device is paired and cannected after the earbuds are turned on, and the earbuds will automatically turn off in 5 minutes.

Pairing &. Connection

Pairing between 2 earbuds

• Two earbuds will automatically pair with each other when powered on.

Pairing between earbuds and Bluetooth device

• Keep the earbuds and the mobile phone (or other Bluetooth devices) within a range of l meter, the closer, the better.
• Open the charging case and remove the earbuds.
• For first-time use, open the Bluetooth of the mobile phone ( or other Bluetooth devices) and search, then select ”Talkie Buds” from the Bluetooth devices list to establish a connection.
• Connection complete.

Once paired and connected with the mobile phone, subsequent uses do not require pairing again. The earbuds will automatically connect to the phone when powered on.

CHARGING

Charge the earbuds
Place the earbuds into the charging case and begin charging.

Charge the charging case
Insert the charging cable into the Type-c port to begin charging.

MUSIC CONTROL

CALL CONTROL

INTERCOM(WALKIE TALKIE) MODE

Communication between L/R earbuds

• Wear earbuds and tap twice on the touch area of either earbuds

Two pairs of earbuds Intercom

• For first-time use, please establish a communication group.
• Once the group settings are complete, there’s no need for further action.
• Each group supports two pairs of earbuds for communication. One must be set as the host and the other as the subunit Both pairs of earbuds must be operated together when creating a group.

Creating a Group

Subunit

• Open the charging case lid.
• Press the button of the charging case twice.
• The LED will blink slowly, indicating it’s waiting for the host to create the group.
• After the group is successfully established, the earbud will restart.

Host

• Open the charging case lid.
• Press the button of the charging case three times.
• The LED will blink rapidly, wait for a moment for the group to be established.
• After the group is successfully established, the eorbud will restart.

Entering communication Mode

• Wear the earbuds and tap twice on the touch area of either earbuds quickly until you hear the ‘Walkie Talkie Mode” prompt.
• Wait for a moment to enter communication mode. When the conversation begins, the LED of one earbud will stay on. The earbuds will turn to Bluetooth mode if the connection is not established within 20 sec.

RESET
When both earbuds are powered on without devices connected. tap 6 times on the touch area of both earbuds, and the LED light will be on and then off. And following that, the earbuds will automatically turn on again to resume the factory settings.

LED INDICATOR &. VOICE PROMPTS

SPECIFICATION

• Model: AH185
• Bluetooth Version: 5.3
• Supported Protocols: HSP, HFP, AVRCP, A2DP
• Battery Capacity: Ear bud 3.7V / 50mAh,
• Charging Case 3.7V / 400mAh
• Battery Life: 10 Hours per Earbud, and additional 25 Hours with the Charging Case.
• Charging Time: l.5 Hours to Charge the Earbuds, 2 Hours to Charge the Charging case Frequency Range: 20-20kHz
• Dynamic Drivers: 10mm, l6Odrivers*2
• Charging Case Port: Type-C
• Waterproof Rating: IPX5
• Weight: Earbud 4.7g, Charging Case 38.5g
• Dimensions: Earbud 351823mm,Charging Case 564628mm

SAFETY GUIDE

Important safety instructions

• Please read this user guide and warranty manual carefully before using the product for the first time.

• Do include this user guide if passing the product on to new users.

• Please inspect the product before use. If there are signs of defects, please stop using the product immediately.

• Use only the product in environments where wireless transmission is permitted.
  Preventing damage to health and accidents

• Do not listen at high volumes, especially for extended periods, to prevent hearing injury.

• The permanent magnetic fields created by this product may interfere with medical implants such as cardiac pacemakers and implanted defibrillators (ICDs). Please always maintain a distance of at least 10cm (3.94″) between the products’ magnetic component/s and implanted medical device/sat all times.

• Keep this product, its accessories, and packaging out of reach of young children or pets, as these may pose choking hazards.

• Do not use the product in an environment that requires your special attention (e.g. in traffic).
  Preventing damage to the product and malfunctions

• Always keep the product dry and avoid exposure to heat sources (including hair dryers, heaters, prolonged strong sunlight, etc.) as this may result in

• product deformation or malfunction. The normal operating temperature of the product is o °C-40 °C or 32 °F-l04 °F.
  Please do not use any attachments, accessories, or spare parts with the product unless they are included with the product or recommended by MOOR Technology Co. Ltd.

• The product should only be cleaned, where necessary, with a soft, dry cloth.

Safety instructions for lithium rechargeable batteries

• In extreme cases, rechargeable batteries may leak and may cause the following hazards if abused or misused: •explosion• fire development *heat generation •smoke or gas development

• Dispose of defective products with built-in rechargeable batteries at special collection points, or return them to your specialist dealer.

• Only use rechargeable batteries recommended by MOOR and the appropriate chargers.

• Only charge the product/rechargeable batteries at ambient temperatures between l0°C/50°F and 40°C/l04°F.
  Switch battery pack-powered products off after use.

• When not using for extended periods of time, recharge the product/ rechargeable batteries regularly (about every 3 months).

• Do not heat the product/rechargeable batteries above 70 °C/158°F. Avoid exposure to sunlight and do not throw the product/rechargeable batteries into fire.

Intended Use/Liability

MOOR will not be responsible for any indirect or consequential loss, loss of profits, or loss of data. The warranty will be void under the following conditions, and the manufacturer reserves the right to refuse to provide service and to demand charges for any costs of servicing from the customer.
There will be no warranty if the product has been modified or repaired by persons not authorized by the manufacturer; Mishandling or wrong application of the product, such as leaving batteries over an extended period in the product causing battery fluid leakage or applying the wrong voltage, manual destruction, damage caused by natural disaster or accident; Product caused by impact sand or liquid damage, tampering, or operating failure; Install and maintain the product without following instructions provided by the manufacturer; If the model number or item code attached to the product has been erased or modified; Modify without authorization the contents of this warranty policy. If the product has been used for commercial, display, demonstration, or rental purposes.
All parts replaced within the warranty period are the properties of the manufacturer. we have the right to handle those parts as necessary.
The warranty covers only the hardware of the product’s main body. All other accessories are not covered within the warranty terms, such as external connection cable, pawer cable, computer cables, software, CD, external cover/ cabinet, and user manual. lFor item description and accessories, please refer to the user manual/instruction manual/user guide).

Manufacturer Declarations
Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way, you help prevent uncontrolled waste disposal and promote the recycling of materials. Electrical and electronic products contain a lot of valuable materials, including metals (such as copper, aluminum, steel, and magnesium) and precious metals (such as gold, silver, and palladium). All materials of the device can be recovered as materials and energy.
The crossed-out wheelie bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products and batteries must be taken to separate collections at the end of their working life. Do not dispose of these products as unsorted municipal waste: take them for recycling. For info on your nearest recycling point, check with your local waste authority.

MOOR is a registered trademark of MOOR Technology Co., Ltd..
For product support, please visit http://www.moor.com.tw, e-mail: info@)moor.com.twmoor.com.tw)

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>