Apacer AS2280Q4U PCIe Gen4 x4 M.2 NVMe SSD User Guide
- June 3, 2024
- Apacer
Table of Contents
Apacer AS2280Q4U PCIe Gen4 x4 M.2 NVMe SSD
Apacer provides a free dedicated M.2 SSD heatsink with special diversion cutting design to effectively reduce the PCIe 4.0 SSD temperature to maintain reading and writing performance at optimum levels. This quick guide is guiding you how to assemble and disassemble the enclosed heatsink of Apacer AS2280Q4U M.2 PCIe Gen4 x4 SSD. Please check it carefully before you installed it to your device.
Contents
- AS2280Q4U PCIe Gen4 x4 M.2 NVMe SSD x 1pcs
- Heatsink Top x 1pcs
- Heatsink Bracket x 1pcs
- Thermal Tape x 1pcs
Assembly Procedure
- Step 1 :Insert the m.2 SSD horizontally according to the bridge in the bracket
- Step 2 :After placing the m.2 SSD in the bracket, please checking if there is room for connector and half moon screw holes.
- Step 3 :Attaching the thermal adhesive tape to the heatsink, and tearing off the release paper for placing the heatsink later
- Step 4 : Place the heatsink on the bracket and align it with one side. Put two fingers on both ends and press down with appropriate force. Press the heatsink into the latch of the bracket
- Step 5 : Check if the heatsink is locked into the bracket and complete the assembly.
Disassembly Procedure
- Step 1 :Prepare a flathead screwdriver. Insert the flathead screwdriver into the one of the latch of the bracket
- Step 2 : Gently detach the latch of the bracket. Then you can detach another latch of the bracket.
- Step 3 :After completing the previous steps, you can gently remove the heatsink from the bracket.
Disassembly completed!
Notice : The enclosed heatsink is free without warranty.
The copyright on this quick guide remains with our company. No part of this quick guide may be transmitted, reproduced or changed. The product specifications, design and this quick guide’s content are subject to change without notice. www.apacer.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>