carousell YK-11 Arespark Earbuds Instruction Manual
- May 14, 2024
- Carousell
Table of Contents
carousell YK-11 Arespark Earbuds
OPERATION INSTRUCTION
Earbuds Pairing
For the first time, you need to find the earphone pairing code from the mobile
phone to pair the TWS earbuds and connect it, and then use it.
Operation instructions for switching the earphone on and off
- Power on : the earphone automatically starts when it is removed from the charging compartment; Or press and hold the left or right earphone for 5 seconds in the off state
- Power on : Put the earbuds back in the charging case; Or press and hold your left/right earphone for 5 seconds
Function operation description
- Click: Play/Pause music;
- Answer/hang up the phone
- Double click: Next song(Right earphone) Last song (Left earphone)
- Three strikes: Increases the volume(Right earphone)
- Decrease the volume(Left earphone)
- Press and hold for 2 seconds each side:Reject an incoming call
- Wake up voice assistant
Charging operation Instructions
- Put the earphones into the charging case, and the charging case will automatically charge the earphones. The LED indicator of the earbuds is red during the charging process; When the earbuds is fully charged, the indicator turns off.
- Use the TYPE-C charging cable provided by the manufacturer to charge the charging case. The indicator light of the charging case flashes red when charging, and the red light is steady on when fully charged
Specification
- Version: VS.3
- Using Time: 2.5-3h
- Charging Time: 1.5h
- Earbuds Battery Capacity: 25mAh
- Charging Case Battery Capacity: 200mAh
- Dynamic Drivers: 13mm 320
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause hamful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co- located or conjunction with any other antenna or transmitter.