Shenzhen AOTO Electronics Co Ltd SID-AT2K210A SID Stand Alone LED Display Instruction Manual
- June 1, 2024
- Shenzhen AOTO Electronics Co Ltd
Table of Contents
Shenzhen AOTO Electronics Co Ltd SID-AT2K210A SID Stand Alone LED Display
FAQ
Frequently Asked Questions
- Q: Can I make modifications to the device?
- A: No, any changes or modifications not approved by the responsible party may void your authority to operate the equipment.
- Q: Is there a specific limit to the portable exposure condition?
- A: The device can be used in portable exposure conditions without restriction, but it is recommended to follow general safety guidelines for prolonged exposure.
Product Diagram
Operating Instructions
- Paring: Press the “PG-” and ” V-” on the panel at the same time, if the LED red light flicker fast, insert the receiver to the computer or the ANDROID device USB interface. If the led light is power off ,paring is successful.
- (Paried successful when out of factory)
The function of the key
- CURSOR LOCK: Short press to lock the cursor, and then return the cursor state. (Optional)
- HOME: After entering the sub-menu you can back to the original main menu directly.
- RETURN: You can press the Return key to put the unit into last interface.
- In the sate of PC the “OK” is the left key of the mouse and “Return” is the right key.
- Press “HOME” can open the internet by this key.
Working Atate Instruction
- While the controller in sate of working condition,
- Press any key the LED light will flash. Loosen the finger, the LED light will be off.
- Cursor speed regulation
- From slow to fast: Press “OK” and “VOL+” at the same time, the speed of cursor pointer will be faster.
- From fast to slow: Press “OK” and “VOL-” at the same time, the speed of cursor pointer will be slower.
Parameters of the product
- Wireless IC: 3-Gyro (Optional) + 3-Gsensor
- Amount of key: 16
- Control distance: ≥ 10m
- Battery distance: AAA x 2
- Working Power: Less than 10mA in the work condition
- Standby Power: Microampere, almost no power, in line with the European “Energy Star” enviromental standard
- Material: Plastic and Silicone
- Color: Black
- Size: 1584114 MM
- Weight: About 47g
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>