Shenzhen OSM Technology Co Ltd OSMWF1 Remote Controller-Fully Control User Manual
- June 1, 2024
- Shenzhen OSM Technology Co Ltd
Table of Contents
Shenzhen OSM Technology Co Ltd OSMWF1 Remote Controller-Fully Control
Remote Controller–fully control
- Power ON / OFF
- Short press to activate night light mode, long press for 2 seconds to activate one-hour her mode. The light will flash twice. Press any button to cancel the timer mode.
- Short press to increase brightness by one level, with a total of five levels. Long press to increase the brightness steplessly (10%-100%)
- Short press to reduce brightness by one level, with a total of five levels. Long 010%- 100educe the origins steplessly
- Switching mode upwards
- Switching mode downwards
- The button defaults to RED light, long press for 2 seconds in any mode to memorize that mode. Can override the mode repeatedly.
- The button defaults to GREEN light, long pauses for 2 seconds in any mode to memorize that mode. Can override the mode repeatedly.
- The button defaults to BLUE light, long press for 2 seconds in any mode to memorize that mode. Can override the mode repeatedly.
- White Light (5000K-5500K)
- Warm Light (1800K-2000K)
- Neutral licht (4000k)
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>