Epicano TPH-2023 Shower Caddy Corner Instruction Manual
- June 1, 2024
- Epicano
Table of Contents
Epicano TPH-2023 Shower Caddy Corner
Questions,
problems, missing parts? Before returning to Amazon, e-mail our customer
service center at Nancy_asap@outlook.com ,
Monday – Friday.
PACKAGE CONTENTS
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble or install the product.
WARNING
- Two people are recommended to ensure safe assembly and to hold pole in place for final
- The load capacity for each basket is approximately 10 lbs.
PREPARATION
- Before beginning assembly, make sure all parts are present. Compare parts with package contents list. If any part is missing or damaged, do not attempt to assemble the product.
- Estimated Assembly Time: 15 minutes Tools Required for Assembly (not included): Tape Measure.
ASSEMBLY INSTRUCTION
- Measure the distance between the tube ledge or the shower stall floor to the ceiling to the nearest half inch.
NOTE: See the below chart to determine how much (C) tubes are needed.
NOTE: No matter the distance, tubes (A), (B) and (D) are ALWAYS used
Please write down your measurements, tubes needed below, you will need this later.
(Caution: The E-tube is an embedded tube and is not included in the overall length measurement.)
-
Insert washcloth bar (G) into the shelf (F).
-
From the bottom of the tube, slide(F) up to the desired position.
-
Place the rubber a-ring(I) {thick end up) onto the tube. Slide the shelf (F) down the tube and fit over the rubber o-ring(I).
-
lnsert the half of the short tapered tube(E) to the long tubes of (B) & (C) or (C) & (D) to connect them. And insert the narrow end of the 2-piece tube (B) into top tube (A).
Note: Part A and Part B should not fit snug. Part A contains a spring inside which keeps tension to the ceiling. Therefore, Part B will not fit all the way into Part A. The pole was designed like this and is not defective. -
To install the assembly, push the top of the pole against the ceiling until it is vertical with the floor; adjust height as needed. To adjust the height of assembly, hold the end of tube with twist lock (B) with the larger diameter. Then, twist the other end counterclockwise to loosen the tension. Raise or lower the pole assembly to desired height, then twist the tube with twist lock (B) clockwise to re-secure.
IMPORTANT
- Before beginning pole assembly, make sure part B is assembled correctly.
- If the 2-piece tube (B) is assembled as shown, continue to the Assembly Instruction section.
- If the 2-piece tube (B) comes apart, position the tubes as shown. Refer to the next instructions to re-assemble the tube. Part B includes 2 tubes (one labeled OUTER, one INNER). The INNER tube has a plastic cam lock mechanism at the bottom. DO NOT REMOVE THE CAM LOCK.
RE-ASSEMBLING THE 2-PIECE TUBE (B)
- Twist the black plastic cam lock mechanism on the INNER tube until it reaches the bottom of the threaded plastic insert.
- Take off the COLLAR, insert the bottom of the INNER tube into the top of the OUTER tube.
- Continue to push the INNER tube to the needed distance, reassemble the collar and continue the Assembly Instructions section.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>