Boltpower BP100 Portable Power Station User Guide

Bolt power BP100 Portable Power Station

Quick Guide

DC Output

• Step 1:
  Press and hold the ON/OFF button (1 second) to turn on the DC output.

• Step 2:
  Press and hold the ON/OFF button (1 second) again to turn off the DC output and the device.

AC Output

• Step 1:
  Press and hold the AC button (1 second) to turn on the AC output.

• Step 2:
  Press and hold the AC button (1 second) again to turn off the AC output only.

Flashlight

• Step 1:
  Press and hold the lights button for 2 seconds to turn on the flashlight.

• Step 2:
  Short press the lights button to switch the LED mode

  • Continuous light mode
  • SOS Strobe mode
  • Continuous flash mode

• Step 3:
  Press and hold the lights button for 2 seconds to turn off the flashlight.

Tips:
BP100 has multiple Protections, including Over Charge Protection; Over Release Protection; Over Current Protection; Short Circuit Protection; Over Power Protection; and Temperature Protection.

Attention:

• When using AC power over 80W (Max100W), the suggested continuous working time should be less than 25 minutes. Otherwise, the overtemperature or other protections will automatically shut down the device.
• When the battery level is lower than 20%, the device will be in low voltage mode. AC output will stop functioning.

Jump Starter Function Quick Guide

Operating Instruction:
If an automobile cannot be started on its battery this portable power station can be used to apply sufficient charge to aid you in jump-starting the vehicle.

Caution:
Ensure the vehicle is in the park (for automatic transmission) or neutral (for manual transmission) and the parking brake is applied. Ensure the product power level is 60% or more.

Step 1 Connect the battery clamp
Check the power station has at least 60% charge. Insert the head of the battery clamp to the Smart Jump Clamps Port. The indicator light flashes red and green for safe use.

Step 2 Connect to the automobile
Connect the 12V battery clips to the vehicle, first connect the red (positive) clip to the (+) battery terminal. Then connect the black (negative) clip to the (-) battery terminal.

Note:
If starting the vehicle is unsuccessful the LED light on the battery jumper clamps lead will turn red. If the LED light is not green please disconnect the jump starter, check it has sufficient charge, remove the clips and clamp lead. Then try again from step 1.

Step 3 Start your vehicle
The LED light on the battery jumper clamps lead will turn green if the clips are correctly connected and the BP100 power station has sufficient charge. Turn the ignition key or press the ignition button to start the vehicle.

Note:

• If you have not started the vehicle within 60 seconds, the LED light on the battery clip lead will turn red.
• If starting the vehicle is unsuccessful, the LED light on the battery jumper clamps lead will turn red.
• If the LED light is not green please disconnect the power station, check it has sufficient charge, remove the clips and clamp lead. Then try again from step 1.

Step 4 Disconnect
After successfully starting the vehicle remove the battery clamp lead from the jump starter.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>