emd auto Audi RS3 Custom 10mm Head Stud Kit Instruction Manual
- June 1, 2024
- emd auto
Table of Contents
emd auto Audi RS3 Custom 10mm Head Stud Kit
Product Information
The DAZA ARP 625+ Head Stud Kit is designed to provide superior clamping force for high-performance engines. Made from high-quality materials, these head studs are engineered to withstand extreme conditions and prevent head gasket failures.
Specifications
- Model: DAZA ARP 625+
- Material: High-strength steel
- Includes: Head studs, washers, nuts, ARP Ultra-Torque Fastener Assembly Lubricant
Installation Instructions
- Ensure thread bores in the block are clean of fluid and debris.
- Install the head studs into the block using a 4mm allen wrench to bottom them out. Tighten your hand tight.
- Install the head gasket and cylinder head.
- Clean the faces on the cylinder head where the washers will sit of any fluid and debris.
- Place washers over the studs with the diamond textured side facing down towards the cylinder head to prevent spinning during torquing.
- Lubricate the threads on each head stud and the bottom of each nut with ARP Ultra-Torque Fastener Assembly Lubricant.
- Install the nuts onto the studs and tighten them hand tight.
- Tighten the nuts in three passes following the torque sequence:
- Tighten nuts 1-10 to 40 ft. lbs
- Tighten nuts 1-10 to 70 ft. lbs
- Tighten nuts 1-10 to 100 ft. lbs
FAQ
- Q: Is it necessary to lubricate the threads of the head studs and nuts?
- A: Yes, it is recommended to lubricate the threads with the provided ARP Ultra-Torque Fastener Assembly Lubricant for proper installation and torque accuracy.
- Q: Can I reuse the head studs and nuts?
- A: It is not recommended to reuse head studs and nuts as they may have experienced deformation or wear during previous use. It is best to use new components for optimal performance and safety.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>