BIYU BAE4C-E8XwU Cleaning Instructions Hub Operations Instruction Manual

Table of Contents

BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-
PRODUCT

$BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $1$$

What is attached to the Woodboy:

$BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $4$$

What is in the box:

$BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $5$$

USING THE WOOD BOY FOR DIFFERENT PURPOSES

Using the Woodboy for sanding with the sanding mesh
- Put the black pad on the drive disc with the pin back and the sanding mesh on the pad.

Using the Woodboy with the pad(s)

Pads are available for various applications.

Black: Intermediate sanding of coatings and usable as a pad for mesh sanding discs.
White: Polishing and brightening waxes
Beige: Scrubbing in and out of wax
Red: Polishing or light scrubbing
Green: Scrubbing and removal of ground in dirt, grease and streaks

BIYU only has black pads, which can be used to attach the mesh sanding discs and for intermediate sanding and scrubbing of floors.

Unroll the power cord completely.
Attach the drive disc $BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $9$$
If you are using the Woodboy for sanding, attach the black pad to the drive disc and attach the sanding mesh to the black pad. $BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $10$$
If you are using the Woodboy for intermediate sanding or floor scrubbing, attach the black pad to the drive disc.
Use the large grey switch to position the handle at hip height. This provides maximum control of the machine. $BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $12$$
Plug in the power cord.
Place the Woodboy in the centre of the room and simultaneously press the yellow switch down with your right thumb and the grey switches on the handle with both hands. You can release the yellow switch once the machine is spinning. The first time the machine will probably swing 1 way, loosen the grey knobs to make the machine stop before hitting anything. The trick is to hold the handle so that the Woodboy keeps spinning on the spot. You only need to make minimal movements with the handle to make the Woodboy go in the right direction once you have 1 found the zero point. This requires very little force.
- Handle up: Woodboy moves to the right
- Handle down: Woodboy moves to the left
- Handle left: Woodboy moves forward
- Handle right: wood boy moves backwards $BIYU-BAE4C-E8XwU-Cleaning-Instructions-Hub-Operations-FIG-1 $13$$