Sollatek AVS3P-0 Avs 3-Phase (Automatic Voltage Switcher) User Manual

Sollatek AVS3P-0 Avs 3-Phase (Automatic Voltage Switcher) User Manual

AVS3P-0

AVS3P-0
APPLIANCE GUARD
3-PHASE AUTOMATIC VOLTAGE SWITCHER

SAFETY

All equipment designed and manufactured by  Sollatek (UK) Ltd complies with the latest safety codes of practice. You should still follow all safety instructions and use caution when installing and operating electrical equipment.

To avoid the risk of a shock, DO NOT expose this equipment to rain, moisture, or liquid spillage. Before attempting to use it, ensure that the contact or solenoid does not exceed 16 amps. The equipment load must not exceed the contact or rating.

START-UP

STANDARD OPERATION

The AVS3P can also be set to protect against bad frequency (goes outside the operating range), phase imbalance (voltage deviation) and/or phase rotation (phases are swapped post-commissioning).

WAIT MODE
Wait Mode provides voltage monitoring and protection against power-back surges and frequent power-ups by ensuring the mains power has fully stabilised before automatically reconnecting it to your equipment after the set wait time has elapsed.

The AVS3P will automatically adjust the wait time depending on the disconnection period to make the total OFF time equal to the set Wait Time. i.e. If Wait Time is 3 minutes and the disconnection is 2 minutes, then the wait time added is just 1 minute.

TIMESAVE™
If the AVS3P has been turned OFF for more than the set wait time, The AVS3P will reconnect the supply to your loads in 10 seconds.

LIABILITY OF THE COMPANY

a) The company shall not be liable, either in contract or in tort for any loss, injury or damage of whatsoever nature or to whomsoever or by whatsoever cause arising directly or indirectly from any defect in the Goods (whether latent or apparent) or as a result of the use of the Goods (save and except any liability for death of or injury to any person resulting directly from the negligence of the company) and the customer shall fully indemnify the company against all claims and demands made upon the company by reason of any such loss or injury or damage.
b) Without prejudice to the provisions of the immediately preceding sub clause the company shall not in any event be liable for consequential or indirect loss or damage howsoever arising under the contract or in relation to the Goods.
c) The customer hereby acknowledges that the restrictions in this clause are fair and reasonable in the circumstances.

WARRANTY

Unless otherwise agreed with the company or where the company has notified the
customer of special terms in respect of specified categories of goods the company agrees at its option either to refund the cost of or repair or replace goods proved to the company’s reasonable satisfaction to have failed under proper storage and use within 24 months of delivery by reason of defects due to faulty design (other than any design made, furnished or specified by the customer) materials or workmanship provided that:

a) The customer shall have followed any instruction issued by the company in relation to the goods and their storage.
b) In the case of defects which would have been apparent to the customer on reasonable examination of the goods on delivery, ‘the’ customer shall notify the company of the defects within 14 days of delivery.
c) In the case of any other defects the customer shall notify the company of the defects in writing within 7 working days of the date when the defect becomes apparent.
d) Where in discharge of its obligation under this clause the company agrees that the customer may undertake any repair work on its behalf the cost of such work shall be agreed in writing between the customer and the company before the commencement of such work.

RETURN OF GOODS

a) Goods supplied in accordance with the customer’s orders cannot be accepted for return without the prior written consent of the company and in accordance with the company’s returns procedure.
b) The company reserves the right to levy a handling, administration or other charge of such amount as it, in its absolute discretion, decides and may deduct this from any credit allowed unless the reason for any return by the customer is due to any fault or breach of these conditions on the part of the company.
c) Returned goods must be sent carriage paid at the customer’s risk to the company’s trading premises or to such other address as the company may direct.
d) The company will not allow credit in respect of returned goods not in fully resaleable condition.

TERMINAL COMPARTMENT

Within the Terminal compartment, there are terminals for electrical connections, unit mounting holes, and setting dials.
Isolate the power to the AVS3P before removing the terminal cover

MOUNTING

AVS3P WIRING

1. Insert the wires through the gland nut and the glands.
2. Connect the corresponding wires to the AVS3P terminals.
3. Tighten the cable gland nuts and secure the terminal cover in place

ELECTRICAL CONNECTIONS

REPAIR/MAINTENANCE

The internal surge protection fuse may blow during a severe surge.

Only a qualified person should carry out repairs. Ensure power is isolated.

ENABLE ADDITIONAL PROTECTION

Phase rotation, voltage phase imbalance & frequency error, can be enabled via the switches inside the top compartment.

Ensure power is isolated before removing the top cover.

2. Turn ON the required function(s) by sliding the switch from right to left.
3. Replace and secure the top cover before powering ON.

Notes:

• WAIT LED indicates alarm level clearance (10s or user-selected DELAY timeout).
• If Delay is OFF, default 10-second delay is automatically activated.
• If LVD is OFF, only default 150V fast OFF is active.
• If HVD is OFF, no high-level voltage protection.

SETTING CHANGE

Note: Always match the set AVS3P limits to the equipment requirements.

SPECIFICATION

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>