ZOUXIKOU Folding Dining Table Drop Leaf Table with 6 Wheels Instruction Manual

ZOUXIKOU Folding Dining Table Drop Leaf Table with 6 Wheels

Dining Table Installation Instruction

1. Set up the accessories and the required parts.

2. Need to knock the pre-buried parts a total of 4 pieces (2 piece of door side plate, 1 piece of top plate, 1 piece of cabinet side panel), knock into the white with threaded pre-buried pieces, the sharp side down, the flat on the top, must knock with the plate a flat, white The white pre-buried parts should not be higher than.
   

3. Install the black screws. Note: the black screws need not be screwed too tightly, you can not see the metal part below. Do not put any accessories into the large black marked holes on the plate , only when splicing the plate.

4. The bottom of the front has four small holes in this piece is the cabinet side panel.

5. Confirm that the cabinet side panel, the black screw side is placed upwards.

6. Connect the laminate to the cabinet side panel. Two laminates are installed on the cabinet side standing board. Note: the direction of the holes should be consistent with the drawings.

7. Fasten the metal eccentric piece in the hole connected to the two plates at the bottom (there is a crescent-shaped gap on the opposite side of the eccentric piece, the gap is opposite to the direction of the black screw sticking out of the bottom according to the flat with the plate, rotate the eccentric piece clockwise and tighten it).

8. Lay the cabinet flat and install the door side panel. And fasten the four eccentric parts connected.
   Note: There are two small holes at the bottom of the door side panel, the direction must be close to the outside of the cabinet.

9. Turn the cabinet over and install the other side of the door side panel. Fasten the four eccentric pieces attached. Note: There are two small holes at the bottom of the door side panel,and the direction must be close to
   the outside of the cabinet.

10. Install the hinges and pins of the two door panels and the top panel. Unfold the hinge with the projecting side up and fasten the screws.

11. Stand the installed cabinet upright and install the top panel. And fasten the connected eccentric parts.

12. Lay the cabinet flat and install the door panel. Keep the door panel on white plastic cap to the top plate, the door hinge can be to the door side panel hinge hole position can be installed. And fasten the screws.
    Note: Because the door panel is divided into left and right If the door plate and the door side plate hinge hole position can not be Changed another door panel can be on.

13. Turn the cabinet over, install the other side of the door panel, and tighten the screws.

14. Inverted cabinet installation folding desktop. Clean the floor do not have foreign objects, and keep the folding desktop and the top plate fit. Hinge the projection side up, and fasten the screws.

15. Install the wheels and tighten the screws.

16. Assembly completed

Note: There is an installation video on the product purchase details page. The combination of the video and installation instructions will make your assembly faster.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>