TECH AOODOR V20231206 Sun Panel Greenhouse Instruction Manual
- June 1, 2024
- TECH AOODOR
Table of Contents
Instruction Manual
V20231206 Sun Panel Greenhouse
Polycarbonate sheets installation steps 
- Disassemble the original damaged polycarbonate sheets.
- Place the original damaged polycarbonate sheets over the new polycarbonate sheets and mark along the edge with a pencil.
- Then use a utility knife or circular saw to cut along the line.
Save this manual for future reference
-
The solar panel needs to be replaced under the following conditions:
« hail damaged « damage
« long-term use weathering -
Preparation before replacement
-
First remove the damaged polycarbonate sheets which need to be replaced.Compare the size between damaged and new polycarbonate sheet.
Generally, the thickness of polycarbonate
sheets is 016 inch (4mm) . If your damaged sheet thickness is 0.20-0.24 inch
(5.00-6.00mm) ,Please buy a Aluminum Foil Tape and paste it around to increase
the thickness. -
Note that the direction of the cutting ploycarbonate sheets should be consistent with the original board.
-
Ploycarbonate sheets can easily be cut with Utility Knife and Saber Saw or manual tools depending on the length of the cutt, the width of the panel, and the type of cut.
Please don’t hesitate to contact us for any further questions, your satisfaction is guaranteed.
customerservice@aoodor.com
https://www.aoodor.com/
VERSION:20231206
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>