WPC Wall Panel Instruction Manual
- June 2, 2024
- WPC
Table of Contents
WPC Wall Panel Instruction Manual
INSTALLATION INSTRUCTIONS
Material (In One Box)
- 6 Pieces WPC Wall Panel
- 1 Piece L Corner Trim
- 20 Chips
Tools Required
- Measuring tape
- Level
- Drill
- Nail Gun
- Hand Saw or table saw
- Safety equipment (gloves, goggles)
- Adhesive (optional)
Pre-Installation Preparation
A clean, smooth surface is essential for a flawless installation. Start by removing any existing wall coverings, nails, or screws. Fill in holes or cracks and sand down any uneven areas. Finally, clean the wall thoroughly to remove dust and debris.To ensure your panels are aligned correctly, set up horizontal and vertical guide lines using a level. These lines will act as a reference throughout the installation process, helping you to maintain a straight and consistent layout.
Cutting
Measure and cut wall panels to the desired length with a hand saw or a table saw.
Fixing the Starter Panel
Align the first panel with your guide lines, ensuring it’s perfectly level. Make sure the tongue side is facing up or towards the direction you will continue installing.
Apply the WPC wall panel to the wall and fasten with a nail gun, use two nails, one each a the top and bottom of the panels. In between the top and bottom you will need one nail approximately every 1-1/4″
Use the Wall Clips to attach the wall panels to each other. A typical installation will use 3-4 clips per panel.
Sequential Installation
After the first panel is in place, continue with the next one, fitting it into
the groove of the starter panel. Apply gentle pressure to ensure a tight fit.
For additional support, you can use adhesive along with screws. Continue this
process, ensuring each panel is level and flush with the previous one.
Remember to stagger the joints for a more natural and aesthetically pleasing
look.
Corner Trims
L Corner Trim can be used to give a finished appearance when you reach the
edge of the wall or to transition between walls. Use the construction adhesive
and nails to secure it to the wall.
Cleaning and Maintenance
WPC wall panels are low maintenance, but regular cleaning will keep them
looking their best. Use a soft cloth and a mild. detergent solution to wipe
them down.. Avoid using abrasive cleaners or scrubbers that could damage the
surface.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>